Length of the Arms on the Lippert JT's Strong Arm Stabilizers
Published 04/27/2017
Question:
What is the length of this part?
asked by: Tatiana
0
Expert Reply:
I went out to the warehouse to measure the length of the arms when extended for the JT's Strong Arm Jack Stabilizer Kit # LC191025. From the center of the hole on one end to the center of the hole on the other end it measures 46 inches extended. When retracted it is 26 inches.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
JT's Strong Arm Jack Stabilizer Kit for Travel Trailers
- Camper Jacks
- Travel Trailer
- Stabilizer Jacks
- Steel
- Manual Jack
- 6 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Air Bags With Wireless Compressor for 2024 Ford F-250 Towing 5th Wheel
- Q&A: How Much Do the Power Mountain Tallboy Off-Road Bottle Jacks Weigh?
- Q&A: Are Safety Chains Required When Using Andersen Ultimate Fifth Wheel Adapter
- Q&A: Is Timbren Rear SES Available With Lower Capacity for 2022 Ram 1500
- Q&A: Surge Protector for 2026 Thor Pasadena 34XG With 50A Service
- Q&A: Can I Leave the Entire B&W Continuum System Connected to the Trailer?
- Q&A: What is the Difference Between the JT Strong Arm Jack Kits 191023 & 191025?
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Still Rocking After Leveling? How to Stabilize Your RV for Good
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Is It Illegal to Leave My Hitch on My Truck?