Wet Bolts, Bronze Bushings, and 1/2 Inch Shackle Straps to Use with Equa-Flex Equalizers  

The Telesteps 7' Folding Ladder #TE27FR is 70" from the top rung to the ground. Each step is 11-3/4" from rung to rung. It is also very light weight as it only weighs 24-1/2 pounds. The Telesteps 10' Telescopic A-Frame Ladder…

The bearing kit #BK3-210 that you mentioned is specifically for 7,000lb axles. For your 2020 Grand Design Reflection 320MKS fifth wheel with Dexter 6,000lb axles, the correct bearing kit will be either #BK3-100 or #BK3-110. #BK3-100 uses a seal with…

The SnapPad Jack Stand Pads like part #SP54FR4 may still work with the Steady Fast or JT Strong Arm Stabilizers but you'd likely need to trim the pad where the arm attaches or raise the arm up a bit from the pads. There is a lip on the pads that…

The Step Wet Bolt for 1-3/4" Double Eye Springs #34007-187-00 you were looking at have a usable length of 2-1/4", which it sounds like match your existing bolts and would be typical for 1-3/4" wide springs. You will need a 7/16"…

You should be able to get the nylon bushings out fairly easily. In the worst case scenario, you can use an old 5/8 inch bolt or piece of round bar stock and punch the bushing out. The bronze bushings can be pounded in with a mallet or a hammer. If…

The Lippert Equaflex equalizers with the part #LC64FR does not come with bushings so for a bronze bushing you could then use the part #D014-077-00 and you'd be set.

The shackle straps included in the Lippert Tandem Axle Equa-Flex AP Kit - Wet Bolts - 3-1/8" Long Shackles #LC64FR you mentioned are 3-1/8" center to center and 4-3/8" overall length as shown in included diagram. Using the longer…

Yes, If you have the the Equa-Flex system already installed on your 2015 KZ Durango Gold with 7000#axle, the Lippert Tandem Axle Equa-Flex W/ Wet Bolts - 3-1/8" Long Shackles #LC64FR are a great choice; this will work as long as they match…

The Wet Equalizer Bolt with Locknut and Grease Zerk #126B2 and Bronze Bushing #D014-077-00 can be used to replace the wet bolts that are frozen on your 2020 Grand Design Momentum 351M. The wet bolts on the Momentum were most likely not serviced…

Thanks for the photo, David! The pin box on your 2022 Salem Hemisphere 369BL is a 1621 model with a 15.5K weight rating. To replace this with a Rota-Flex you need the part #LC328330. This is rated for 18K, but the extra bit of capacity won't be…

Hi KJM; assuming you have the factory trailer hitch the correct TorkLift camper tie-downs for your 2024 Sierra 3500 dually is the Custom Fit Tie Down Kit With TL44FR | TL84FR #TL94PR. This will fit with that built-in step you're referring to as…

Hey Donald, thanks for reaching out! I recommend using the MORryde Cushioned Pin Box #MR84VR over the Curt Rota-Flex #LC328330 any day because it has better cushioning technology. Back in the day when the Rota-Flex was first released it was…