Is Spacer Plate Needed to Install Curt Friction Sway Control Bar # 17200
Updated 03/17/2017 | Published 03/16/2017
Products Featured in This Question
Question:
What is the purpose of the plate that goes with the ball? Is it really neccessary? Can not just the 4 bolted ball mount by itself?
asked by: Glenn
Expert Reply:
If you are talking about ball and plate assembly # C17201 the ball is welded to the plate so it is all 1 piece. But if you are talking about the spacer that comes with sway control bar # 17200 then it should be used to ensure there is adequate space between the sway control bar and the trailer frame. In some situations it isn't needed. Other times it is needed. If the A-frame is the standard 50 degrees then you will likely not need it but it is possible.
Product Page this Question was Asked From
Replacement Ball and Plate Assembly for Curt Friction Sway Control System
- Accessories and Parts
- Weight Distribution Hitch
- Sway Control Parts
- Ball
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Difference Between Underslung and Overslung Coupler For Weight Distribution System
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: Reese Towpower 3216 Chain Kit Availability and Replacement Option
- Q&A: How To Install The Replacement Ball and Plate Assembly for Curt Friction Sway Control System
- Q&A: Recommended Weight Distribution System for a 7,000 lbs Big Tex 70DM Car Hauler
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: EOH Actuator and Brake Lines For Nucamp Tag XL Boondock Adding Disc Brakes
- Q&A: Replacement Hub for Tie Down Engineering 11033
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: Determining Trailer Tongue Weight
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size