Needing a Replacement Mounting Bracket for a Pollak 7-Way Connector
Updated 02/24/2017 | Published 02/23/2017
Products Featured in This Question
Question:
Trying to find the correct replacement mounting bracket for my Pollak 7-pin trailer connector. Everything I see has the wrong bolt hole spacing. Mine is 2 1/2inch x 1 3/4inch center to center which is about 1/4inch larger than the brackets Ive seen.
asked by: Bob
0
Expert Reply:
The replacement mounting bracket for a Pollak 7-Way connector is # PK12711U.
the bracket is the replacement bracket for Pollak products # PK11893, # PK12703, and # PK12907.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Mounting Bracket and Installation Hardware - Pollak 7-Pole, RV-Style Trailer Connector - Vehicle End
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 7 Round
- Pollak
more information >
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: What Bracket Goes With The TowSmart ProClass Trailer Connector TS59RR?
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Brake Controller for 2022 Chevrolet Traverse With Factory Tow Package
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Best Trailer Wiring Harness For 2025 Nissan Frontier S Model
- Q&A: Blue Ox Flat Tow Setup for 2022 Jeep Cherokee Trailhawk
- Q&A: How To Determine If A Brake-Lite Relay Is Needed On My Flat Tow Setup
- Article: How to Measure for Trailer Hitch Drop