Where Does Red wire of Roadmaster Brake Lite Relay Run
Updated 02/20/2017 | Published 02/18/2017
Question:
on the roadmaster brake-lite relay 88400 the red wire that is hooked to the green wire where does the red wire go too. all the paper work says is brake signal out put.
asked by: Richard S
0
Expert Reply:
The red wire of the Roadmaster Brake Lite Relay kit part # RM-88400 runs to a circuit on the vehicle that only sees voltage when the key is in the on position. I attached a diagram for more info as well.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Roadmaster Brake-Lite Relay Kit for Towed Vehicles
- Flat Tow Brake System
- Brake Light Relay
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Is Demco Stay IN Play DUO Inline Air Pressure Regulator Needed For 2025 Ford Maverick Hybrid
- Q&A: Will Curt RVibrake Shadow 2 Fit 2026 Ford Maverick Hybrid
- Q&A: Recommended Parts to Flat Tow a 2006 Jeep TJ
- Q&A: Parts Needed to Flat Tow 2024 Ford Maverick Hybrid
- Q&A: Blue Ox Flat Tow Setup for 2026 Ford Maverick Hybrid
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Q&A: Stop Light Switch and Brake Light Relay for 2025 Ford Maverick Hybrid
- Article: Must-Have Flat Towing Components
- Q&A: Recommended Parts to Flat Tow a 2014 Honda CR-V
- Article: Trailer Wiring Diagrams
- Article: How to Choose a High-Low Adapter
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)