Is Adapter Available To Mount Fulton Jack With 3x4 Bolt Pattern To Trailer Plate With 5x4 Pattern
Updated 01/16/2017 | Published 01/13/2017
Question:
I purchased a Fulton f2 jack for my ranger trial trailer. I took off the old jack and went to put the new one on and the bolt pattern is not the same. My trailer has a 5x4 inch bolt pattern and the jack is a 4x3. Is there a adaptor plate that will work for my trailer that I dont have to weld on?
asked by: Robert G
Expert Reply:
I wish we had an adapter that woudl let you use the Fulton F2 Swing-Up Trailer Jack, PART # F1413100334 with the 5 x 4 mounting plate on your trailer but we do not have any available.
You will need to either have the plate you have cut off and replaced with the Mounting Bracket and Hardware, part # F500277 or possibly mount the mounting plate in a different place on your trailer, maybe on the other side. I wish I had a better option but we do not carry adapters for mounting the jack.
Product Page this Question was Asked From
Weld-On Mounting Bracket and Hardware for Fulton Swing-Up Trailer Jacks with 3" x 4" Mount
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Fulton
more information >
Continue Researching
- Q&A: Replacement Bearings and Brake Assemblies For 1998 Dexter 9000lb Axle
- Q&A: Recommended Mounting Bracket For Fulton F2 Jack
- Q&A: Troubleshooting LED Trailer Lights that Flicker When Vehicle is Off
- Q&A: Which Solar Panel Should I Use to Keep Battery Charged That Runs Trailer Jack
- Q&A: Will Roadmaster Comfort Ride Shock Absorbers Work on Trailer with Flipped Axles
- Q&A: Depth of Dexter Hydraulic Jack from Bracket To Outer Edge of Pump Enclosure
- Q&A: Will Dexter Self-Contained Hydraulic Jack Fit Dump Trailer
- Article: Boat Trailer Guides: Which are the Best?