Recommended Suspension Enhancement For 1996 Roadtrek Class B Motorhome

Question

Question:

how about the Timbren system and which would work better?

asked by: Tom J

1

Helpful Expert Reply:

We have a system that will work great on your 1996 Roadtrek.

I recommend the RoadActive Suspension Kit, part # RAS4612-DV. This system not only adds strength to the leaf springs but it also helps reduce sway and body roll.

I called my contact at RoadActive and they said you will want to make sure you have at least 4-inches clearance above the leaf springs from the center of the axle back to the rear eye on the leaf spring to get this to work.

expert reply by: Jeffrey L

1

Tom J.

1/4/2017

how about the Timbren system and which would work better?

Jeffrey L.

1/23/2017

We do have Timbrens like part # TDVR350R that would work on your motorhome as well. The biggest difference between the RoadActive system I recommended and the Timbren system is that the RoadActive system is always active where the Timbrens are not active when there is no load and will engage as more weight is added to the motorhome. Another system you may want to consider is the SuperSprings Suspension Stabilizer, part # SSA8MTKT. These sit above the leaf springs and help reduce sway and also prevent sagging. These work like sway bars seen on larger motorhomes. The rollers on the ends of the springs activate when under a load and do not when there is no load.

Answer 1

The Roadmaster Rear Anti-Sway Bar part #RM-1129-111 is a fit for a 1996 Dodge Roadtrek with or without water tanks to the best of my knowledge. That said, these water tanks may have to be removed for installation but only temporarily to get the…

view full answer...

Answer 2

The 2,000 pound weight capacity listed for the RoadActive Suspension Kit #RAS4612-DV referenced in your question refers to any additional load carried on your 1996 Road Trek 190 and that is applied to the axles. The suspension kit capacity does not…

view full answer...

Answer 3

Running more than one suspension enhancement kit can sometimes "work" but the problem is you end up with such a harsh ride quality that it becomes unbearable. For that amount of support you are wanting from your 1995 Dodge Van B3500 the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 8

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

view full answer...

Answer 11

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 12

Hello Barry, Since you already have a weight distribution (WD) hitch and are only experiencing a little rear sag, I recommend going with SumoSprings. I typically only suggest Timbrens for those who are towing heavy loads regularly, as they can create…

view full answer...

Recommended Suspension Enhancement For 1996 Roadtrek Class B Motorhome

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching