What is the Depth of Bearing Buddy BB1980A-SS One Installed in Hub Bore
Published 12/08/2016
Question:
Hi, Can you tell me the overall depth of the 1980A-ss Bearing Buddy? In other words, I am trying to deptermine how far the BB will stick out of the hub. I have somewhat of a clearance issue with the center caps. Thanks
asked by: Don P
Expert Reply:
I went to our warehouse and pulled a sample of the Bearing Buddy kit # BB1980A-SS that you referenced so I could measure it for you. From the shoulder (the point that remains outside the hub bore) out to the outside edge of the stainless housing the depth is 37mm or 1.46-inches. The flexible plastic dust cap will add roughly another 3mm or 0.12-inches to that depth if installed on the stainless housing.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1980A-SS w/ Auto Check - Stainless Steel (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.99 Inch
- 2000 lbs Axle
- 2500 lbs Axle
- 3500 lbs Axle
- Bearing Buddy
more information >
Continue Researching
- Shop: Brophy Swiveling D-Ring Anchors w Backing Plates and Hardware - Bolt-On - 2,000 lbs - Qty 4
- Q&A: Troubleshooting Interior Lights Not Working for Enclosed Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Reverse Lockout Solenoid For Dexter DX12.5 Actuator
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Most Popular Wheel Bearings
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Is There Fas-Top Topper that Fits 2024 Ford E-350 Long Bed
- Q&A: Difference Between Bearing Buddy 1980 Models
- Q&A: Should the Grease Bolts Be Tight on the Dexter DX7.5 Drop-N-Go Brake Actuator?
- Article: Trailer Lighting Requirements
- Q&A: Looking For A Replacement Actuator For My Titan 10 Surg-O-Matic
- Article: Trailer Wiring Diagrams
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)