Wiring a 4-Way Connector that has 5 Wires Running Into It

Published 11/11/2016

Products Featured in This Question

16 Gauge, 4 Conductor Bonded Parallel Wire - Per Foot

(239)

$2.47

Hook Probe Circuit Tester

(70)

$13.12

Question:

The connection at my truck has 5 wires going into the connector but only 4 connectors on the plug. I am assuming that this is for individual wires for each side for running lights, Help?

asked by: Jim

Expert Reply:

You are correct. A 4-way harness that has 5 wires going into it generally uses two of them for the running lights. This prevents the need for a jumper wire from one taillight to the other. If you're replacing the 4-way you will want to test each wire with a circuit tester, like #PTW2993, to make sure you have the two wires that are both running lights on the same circuit. They're usually ran into the pin closest to the ground, but testing is the only way to be sure.

expert reply by: Charles S