Are all Pins of the Power Grip RV Power Cord Adapter # CAM55185 Active

Question

Question:

on some 30 to 50 amp adapters you only have 1 hot leg at the 50 amp end, I know this is to help eliminate drawing to much power but because of the way my rig is wired I need power to both legs and will have to control power usage myself. So the question is are both the legs hot on the 50 amp side using this adapter.

asked by: Tom

0

Expert Reply:

All of the pins on the Power Grip RV Power Cord Adapter # CAM55185 will be active. There isn't a single pin that is used with this adapter.

expert reply by: Jameson C

0

Answer 1

Yes, in order to power your 50 amp food truck while using a 30 amp power source you will want to use the Mighty Cord Dogbone RV Power Cord Adapter part #A10-3050FBK if the power source is from an electric box or the Mighty Cord Generator Adapter for…

view full answer...

Answer 2

The Mighty Cord RV Power Cord Adapter, #A10-3050D90VP is used to adapt your RV's 4-prong 50-amp power inlet for use with a 30-amp 3-prong extension cord/Power Pedestal. A 50-amp plug has four prongs with two of them providing 50-amps of power…

view full answer...

Answer 3

Hey Stanley. The app screen for the Power Watchdog Surge Protector with Bluetooth item #HU47FR is going to look like the picture I attached below. It'll show the wattage being used along with the amps and voltage. The Power Watchdog Surge…

view full answer...

Answer 4

Hey Mike, thanks for reaching out! I'm not quite sure what product you're referring to, but if you're talking about having a 50A RV and hooking it up to a 20A or 30A power source, you definitely can do that with the Power Watchdog…

view full answer...

Answer 5

Hey Marc, yes you can use the 50 amp Power Watchdog Surge Protector #HU82VR with a 30 amp power source. It will work just fine without any issues.

view full answer...

Answer 6

Rick, you won’t need to double up. Both the 30A #HU72VR and the 30A #HU84ZR already have full surge protection, emergency shutoff, and monitoring built in. Running them in series could actually create more hassle and even issues perhaps. If you…

view full answer...

Answer 7

Yes Keith, the Watchdog Surge Protector #HU72VR will still protect your RV even if you’re plugged into a 15A residential circuit with an adapter like Mighty Cord RV Power Cord Adapter - 30 Amp Twist Lock Female to 15 Amp Male #A10-1530DBK. It doesn’t…

view full answer...

Answer 8

While the Portable Power Watchdog Surge Protector #HU67FR can be plugged into a 15 or 20 amp outlet using an adapter it wouldn't offer much surge protection for that circuit since the circuit would need to prevent surges above 15 or 20 amps…

view full answer...

Answer 9

Greg, the Power Watchdog Surge Protector #HU72VR gets wired as the first stop on your shore power cord, right where it enters the coach. That way it protects the transfer switch if you have one, your breaker panel, and all appliances. With a transfer…

view full answer...

Answer 10

Hey Dave! The input for the 50A Power Watchdog Surge Protector #HU82VR is at the bottom while the output is at the top. I'm attaching a clip from the instructions on Hughes site so you can see the correct orientation. I've requested for the…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Are all Pins of the Power Grip RV Power Cord Adapter # CAM55185 Active

Product Page this Question was Asked From

Continue Researching