Draw-Tite Front Mount Hitch on 2014 Toyota Tacoma

Question

Question:

I notice that you have a Front Mount Trailer Hitch Item number 65070. It is for a Toyota Tacoma 2013. I would like to know if you have a photo of it after being install on the vehicle ?? I would like to see how it looks. Thanks

asked by: Victor S

0

Expert Reply:

I attached a photo of the Draw-Tite Front Mount Trailer Hitch Receiver # 65070 installed on a Toyota Tacoma.

As you can see the hitch sits just below the front bumper. The line pull is rated at 9000 lbs.The verical load is rated at 500 lbs and the gross trailer weight is rated at 5000 lbs. I attached a link for installation instructions as well for this hitch.

expert reply by: Jared P

0

click to enlarge

Answer 1

To retain the skid shield, you'll want to go with the Draw-Tite #65070. In order to install the Curt #31313 front hitch on your 2014 Toyota Tacoma, the bumper beam end caps and the front skid shield would need to be permanently removed. For the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 5

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 8

Hey Sean, yes you can use the TowSmart Adjustable Ball Mount #TS89VR in the Gen-Y Voyager Ball Mount #GY52JJ. This will provide cushioning to the adjustable ball mount plus some additional drop. What are you planning on towing with this setup?

view full answer...

Answer 9

Hi Steve; the factory hitch on the 2013 Tacoma has the bumper brackets integrated into the hitch. You can replace it with the etrailer Trailer Hitch #e98850 but you will have to remove the old hitch and find new bumper brackets to complete the…

view full answer...

Draw-Tite Front Mount Hitch on 2014 Toyota Tacoma

Continue Researching