Frame Size Equalizer Weight Distribution Brackets are Compatible with

Question

Question:

Will this fit a 6inch trailer frame? There are no specifications about size that I could find on this bracket and the outer link bracket?

asked by: Angela

0

Expert Reply:

The standard spring bar brackets in the Equal-i-zer 4-Point Weight Distribution Systems # EQ37140ET and # EQ37120ET will fit trailer frames up to 6-inches in height.

expert reply by: Jameson C

0

Answer 1

I have attached photos showing the dimensions of the Replacement Sway-Control Bracket #EQ95-01-5600. The larger, L-shaped bracket measures 10 inches long x 2 inches wide and the smaller brackets measure 8-1/4 inches long x 1-1/2 inches wide. These…

view full answer...

Answer 2

I'd see if you can get them to replace those plates. They really shouldn't be bending like that. We have them with part #EQ90-02-5200 but I would think they should replace them for bending them like that.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 5

At one point Equal-i-zer bars could be swapped easily to convert a kit to a higher/lower tongue weight range, but we now know that you have to replace the head of the unit with the bars. So with the bars part #EQ90-01-1099 that you need you will need…

view full answer...

Answer 6

I have a solution for carrying the head of your weight distribution system but I am sorry I checked with HitchGrip and the only product they make is the HitchGrip Carrying Tool for Weight Distribution Head Assembly with 2-5/16" Ball item…

view full answer...

Answer 7

That is definitely a feature which worries me about the B&W Continuum Weight Distribution System #BW78FR. While there is not a specific measurement I can give you as the bars move up and down depending on the load placed on the bars, B&W…

view full answer...

Answer 8

Hey Ludwig, Depending on your lug nut type, wheel size, and wheel material it changes what the torque specs are. Since I am not sure what came on the trailer or what size lug nuts you have based on the trailer I have attached a chart that gives the…

view full answer...

Answer 9

Don't worry, I can help explain how you will need to adjust your weight distribution system for the best tension. First thing to know is that there is no particular set amount of bar tension that is standard for all vehicles. It will depend on…

view full answer...

Answer 10

The trunnion bars on your weight distribution system do need to be parallel to the ground in order to operate properly. The goal of a weight distribution system is in part to help stop sag, however, so I would double check just to ensure everything…

view full answer...

Frame Size Equalizer Weight Distribution Brackets are Compatible with

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching