Is there Any Drilling Required to Install Curt Trailer Hitch # C11202 on a 2009 Nissan cube

Updated 10/15/2010 | Published 10/14/2010

Products Featured in This Question

Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"

(8)

$401.17

Curt Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-1/4" Long - 3,500 lbs

(2313)

$37.13

Question:

Do i have to drill at all? Frame or hitch

asked by: Patrick N

Expert Reply:

To install the Curt Trailer Hitch Receiver, # C11202, on a 2009 Nissan cube, you will need to enlarge holes that are already there, not drill new holes. I have included a link to the installation instructions that shows where the holes will need to be enlarged.

If you plan on doing some towing, the recommended ball mount is # C45520 for use with ball # 19256 (1-7/8 inch diameter) or # 19258 (2 inch diameter). For trailer wiring, use the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # HM11143705.

expert reply by: Michael H

Michael H.

10/15/2010

To install the Curt Trailer Hitch Receiver, # C11202, on a 2009 Nissan cube, you will need to enlarge holes that are already there, not drill new holes. I have included a link to the installation instructions that shows where the holes will need to be enlarged. If you plan on doing some towing, the recommended ball mount is # C45520 for use with ball # 19256 (1-7/8 inch diameter) or # 19258 (2 inch diameter). For trailer wiring, use the Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # HM11143705.