Can a Bent Landing Gear Jack Leg be Straightened
Updated 08/08/2016 | Published 08/06/2016
Question:
My left front landing gear jack is bent and is binding when lowering or raising the unit, it will not retract all the way. This is a 2012 Sandpiper 5th wheel, model RL340. Can the landing gear tubes be safely be straightened?
asked by: Tom S
Expert Reply:
No, it is not recommended to try to straighten a bent jack tube. That would put more stress on the steel and there could also be internal damage that is unseen from the outside. I recommend replacing the damaged leg to avoid all potential issues related to a bent leg. I have included a link to the replacement legs that we carry.
Product Page this Question was Asked From
Lippert Components 32" Lead 5th Wheel RV Landing Gear Drop Leg w/Snap Pin
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Driver Leg
- Lippert
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Availability Of Replacement Rod And Nut For Lippert Ground Control 3.0 Jack Leg
- Q&A: What Replacement Lead Leg Do I Need for My 2011 Keystone Montana Trailer?
- Q&A: Will Replacement Front Jack for Lippert Ground Control 3.0 System Work On 2021 Open Range 5th Wheel?
- Q&A: Will Curt Helux Pin Box Work With Demco Autoslide DM8550038?
- Q&A: Landing Gear for a 2009 Heartland Bighorn 5th Wheel Trailer
- Q&A: How to Find the Correct Replacement Lead Leg for 5th Wheel Landing Gear
- Q&A: Determining The Correct Replacement Landing Gear For A 2006 Rage'n 5th Wheel Toy Hauler
- Article: Can I Put Wallpaper in My RV?
- Article: RV Winterization Guide: Step-by-Step Process from the Pros
- Article: Holiday 2025 | Best Gifts for RVing
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 7 Facts About RV Antifreeze Every RVer Should Know
- Article: Cleaning Your RV Black Water Tank in 4 Easy Steps