E-Track End Cap Recommendation for More Finished Look
Published 08/05/2016
Products Featured in This Question
Question:
What is the mounting procedure for etrack that is flush with floor? Like a d-ring. Also what is used as trim to dress up the look?
asked by: Kevin
Expert Reply:
For an end cap for the horizontal e-track the part # ET8730 would give the track a more finished look.
You can mount the E-Track Trailer Cargo Control, # EM59150, using wood screws if the mounting surface is wood. If it is sheet metal, I would use sheet metal screws. Basically, match the screw with the material you are mounting to. There is no recommended way of installing the E-Track as installation is the responsibility of each individual installer. The more points you can contact the trailer frame, the more secure the spare tire will be.
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 2' Long - Qty 1
- E Track
- E Track Rails
- Horizontal
- 5 Inch Wide
- 2000 lbs
- 2 Feet Long
- Erickson
more information >
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Can E-Track be Driven Over and be Used to Secure Vehicle Tire To
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: What Screws do You Recommend to Use with the CargoSmart X-Track Cargo Organizer?
- Q&A: Hardware for Attaching E-Track to Wood Floor and Walls
- Q&A: Flush Mounted LED Lights for Flatbed Trailer
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Are The Trimax Hidden Padlocks Available Keyed Alike?
- Q&A: Hydraulic Disc Brake Conversion For 2008 Trailer With Dexter 10K Axles
- Q&A: What are the Overall Measurements of 4-Slot Horizontal E-Track - Zinc Plated Steel
- Article: Rust Prevention
- Article: Trailer Tire Sizing
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: 5 Things to Know About Weight Distribution Hitches