Would Replacement Lens part # A31AB Replace Lens of Reflect O Lite Bargman 478

Question

Question:

Hi, I just wanted to confirm that the amber A31AB lens will directly replace a Reflect-o-lite Bargman 478 they discontinued them in 2013. I need to replace all the clearance light lenses on a 1983 RV but dont want to have to replace/rewire the bases. Thanks!

asked by: Steve D

0

Expert Reply:

Yes, the part # MCL31AB that you referenced would replace a 478 Reflect o Lite Bargman clearance light lens as they are essentially the same.

expert reply by: Jameson C

0

John

4/27/2024

hi i need replacement bulbs for #478 reflect O lite side markers for my camper.. mini bulb

Jameson C.

4/29/2024

@John We don't carry just that bulb. Only option would be new light assembly like the part # MCL31AB.

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 8

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Would Replacement Lens part # A31AB Replace Lens of Reflect O Lite Bargman 478

Products Featured in This Question

Continue Researching