Troubleshooting Keystone Raptor Toy Hauler Slow Landing Gear
Published 05/27/2016
Question:
Power landing jacking are not jacking equally. One side sits lower than the other and the level is off. Nothing leaking just seems the one sits lower than the other.
asked by: Jeff Y
Expert Reply:
Slow operating landing gear is typically the result of one of the following causes; a low battery voltage, a bad ground for the jack motor, or a lack of lubrication on the jack screws and pinion gear.
It is also very possible that the motor could be bad; if it were me, I would check to be sure that the current system had good voltage, ground, and, lubrication before replacing the motor.
If you have Lippert landing gear then the replacement motor the part # LG-142178 would work for you.
I have linked the replacement motor to this page for your convenience.
Product Page this Question was Asked From
Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Continue Researching
- Shop: Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Q&A: What is the Replacement Motor
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor
- Q&A: Replacement Motor for Lippert Model 1-065-041012-01 Landing Gear
- Q&A: Replacement Motor for a 125340 Motor Model Number 1a065012-02-01
- Q&A: Replacement Landing Gear Motor for a ADTH E226168
- Q&A: Replacement Gearbox for Landing Gear With Motor 125340
- Q&A: 5th Wheel Landing Gear Motor Comparison for Part Number From LCI 142178
- Article: Carrying Bikes While Towing a 5th Wheel Camper Trailer
- Article: Best Landing Gear
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Converting Your RV Water Heater to Tankless
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Mount a Truck Bed Camper