Which Way Should the Holes of the Combo Bar part # C49511 Face When Welded On
Updated 04/08/2016 | Published 04/06/2016
Question:
im welding this to a steel plate do you want the hole in the tubing on the outside where you slide the pin thru or do you put this on the back side where you cant see the pin
asked by: Louis
0
Expert Reply:
The holes that are in the Combo Bar part # C49511 that you referenced are for a hitch pin to fit through. You would want the holes to be on the sides so that a hitch pin would slide through from either left to right or right to left.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
18" Combo Bar with 2-1/2" Trailer Hitch Receiver - Unpainted
- Hitch Fabrication Parts
- Receiver Tube
- 18 Inch Long
- Raw Finish
- Fits 2-1/2 Inch Hitch
- 1/2 Inch Thick
- CURT
more information >
Continue Researching
- Q&A: Power Mountain Tallboy PM75ZR Jack Stand for Lifted Ford F-150
- Q&A: Is It Safe to Tow Cross Country Using a 2-1/2 to 2 Reducer Sleeve
- Q&A: Can 2-1/2 inch Hitch Ball Mount be Extended Out Further
- Q&A: Recommended 21" Hitch Extender for a Ram 2500
- Q&A: Safety Chain Recommendation for Curt Hitch Extender part # C45048
- Q&A: How Much Does Hitch Extender Reduce Tongue Weight Capacity
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: How Much Do the Power Mountain Tallboy Off-Road Bottle Jacks Weigh?
- Article: Brake Controller Installation: Starting from Scratch
- Article: Best Hitch Cargo Carriers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: My Trailer Hitch Doesn't Fit