Can the Lippert Components 24 Install on Both Sides of Trailer
Published 09/04/2015
Question:
is the riety hand or left hand
asked by: Richard M
0
Expert Reply:
The scissor jack part # LC285325 that you referenced can be installed on the right or left hand side of a trailer. In other words they are ambidextrous.
To raise the jack you would turn the handle clockwise, and to lower it counter-clockwise.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Lippert Scissor Stabilizer Jack - 24" Lift - 5,000 lbs - Qty 1
- Camper Jacks
- 5th Wheel Camper
- Pop Up Camper
- RV Motorhome
- Teardrop Camper
- Travel Trailer
- Scissor Jacks
- Steel
- 4001 - 5000 lbs
- Manual Jack
- 24 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Continue Researching
- Q&A: Scissor Stabilizer Jack Base Hole Spacing Dimensions
- Q&A: Recommended Installation Hardware for etrailer Scissor Stabilizer Jacks e36VV
- Q&A: Soft Start for Grand Design Reflection 297RSTS With Coleman-Mach 48204-669
- Q&A: Is There an RV Roof Vent Assembly that Can be Thermostatically Controlled
- Q&A: Can You Replace the Threaded Rod in the RV Scissor Jacks
- Q&A: Can I Install A Propane Tank Inside A Tongue Mounted Toolbox?
- Q&A: Troubleshooting Installation of B&W Companion 5th Wheel Hitch in 2001 GMC 2500
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Steel vs. Aluminum Ball Mounts