Hitch Recommendation for a 2001 BMW 325xi Wagon
Published 09/01/2015
Question:
I am considering buying a 2001 BMW 325xi wagon. It has been modified with a MTECH ZHP rear bumper. I have a pic if you need it. Your description of your hitch receivers says except M versions. Can I cut into the bumper to make this receiver fit? Thanks
asked by: Donna S
Expert Reply:
Since your 2001 BMW 325xi isn't an actual M model the Curt hitch part # C11174 that you referenced would technically fit if it wasn't for the aftermarket bumper. Since this hitch hasn't been tested with that bumper I can't say for certain what it would take to make the hitch fit.
Based on how this hitch installs it should still bolt up, but it would be a matter of trimming the rear bumper potentially to get it to fit your vehicle. I attached an install video for you to check out as well as a picture that shows the hitch installed.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Light for RV Bargman 84 Series Trailer Light
- Q&A: Looking For Replacement 7-Way Plug With Double Prong Design
- Q&A: Availability Of Trailer Hitch For 2026 Genesis GV70 3.5T Sport Prestige
- Q&A: Difference Between Curt Trailer Hitches C11174 & C11178 and Bike Rack Options for 2009 BMW 560i
- Q&A: Trailer Hitch Receiver Fit on 2001 BMW 3 Series Sedan
- Q&A: Curt VS Draw-Tite Hidden Cross Tube Trailer Hitch Receivers For a 2018 Subaru Outback
- Q&A: Trailer Hitch Recommendation for 2019 Subaru Outback
- Article: Best Bike Racks for Electric Bikes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: How to Tell the Weight Rating of a Trailer Axle