Recommended Cutting Method for the Andersen Camper Wheel Chock and Leveler AM3604
Published 08/29/2015
Question:
I cannot fit the 2nd pair of the Levelers between the wheels. Instructions say you can cut up to 4inch from the end. HOW DO YOU CUT THEM PROPERLY WITHOUT DAMAGING THEM ? Thank you,
asked by: Bill D
0
Expert Reply:
We had a customer come back and say that they used a miter saw to cut their Levelers part # AM3604 down to the right size and it worked well. That would probably be the safest method so it would be what I would recommend.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Andersen Camper Wheel Chock and Leveler
- Wheel Chocks
- Wheel Chock
- RV
- Trailer
- Plastic
- Smooth Surface
- 1 Chock
- Red
- Andersen
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does Brandmotion FullVUE Digital Rear View Mirror with HD Backup Camera Come with CHMSL Camera
- Q&A: Will a Grille Guard For 2025 Toyota Tacoma Interfere With Sensors
- Q&A: Will Storing Trailer on Grass/Dirt Damage Trailer Tires
- Q&A: Replacement Hubs, and Brake Assemblies for a Dexter 6,000 lbs Axle
- Q&A: What is Best Rear Suspension Enhancement for 2026 GMC Sierra 3500 Denali Towing 5th Wheel Camper
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Can I Install A Propane Tank Inside A Tongue Mounted Toolbox?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Recommended Front Hitch for a 2023 Ford Transit T250 Eco-Boost
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Converting Your RV Water Heater to Tankless
- Article: How Much Solar Power Do I Need For My RV?
- Article: How to Install E-Track in 3 Easy Steps
- Article: What Do I Need To Tow A Trailer?