Grease Cap Recommendation to Replace Cap that Measures 1.90 Inches

Question

Question:

I have a 1.90 outside diameter grease cap and the inside is 1.80 diameter will this cap work

asked by: Bryan

0

Expert Reply:

You would want the part # F001524 which has an outer diameter of 1.943 inches. This would install in your hub and provide a nice tight fit.

The part # F001503 would be too small and wouldn't stay in your trailer hub.

expert reply by: Jameson C

0

Answer 1

The Replacement EZ Lube Drive-In Grease Cap #21-41-1 that you referenced has an overall height of 1-3/8". From the top of the grease cap to the bottom edge of the lip that stops it on your hub is measures 1" tall. If you don't already…

view full answer...

Answer 2

You will want to use a dial caliper or micrometer to measure the inner diameter of the hub you have on your trailer to determine what size cap would be needed. Check out the picture I attached that shows this measurement being taken on a hub. I…

view full answer...

Answer 3

The Bearing Buddy Bearing Protectors #BB1938SS are the closet we have to your 1.90" measurement. These fit a hub bore of 1.938". If you can send me some additional information on your hub/spindle including bearing sizes and grease seal…

view full answer...

Answer 4

You need to use the inner diameter of your hub bore to determine what size Bearing Buddy you need. If you measured the outside diameter and chose your Bearing Buddy on that, then it will not fit. If you measured the inner diameter, then as you said,…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Grease Cap Recommendation to Replace Cap that Measures 1.90 Inches

Continue Researching