Trailer Hub Grease Cap for Hub with 1.980 inch Opening
Published 07/31/2015
Question:
looking to buy ?E-Z Lube Grease Caps. not sure if you have the right size? I measured the grease cap on my trailer I get 1.980.
asked by: Kurt
0
Expert Reply:
You would want the EZ Lube Drive in Plug with Cap part # RG04-040. This has been confirmed as a fit for trailer hubs that have a hub bore of 1.980 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Grease Cap, 1.99" OD EZ Lube Drive in with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- EZ Lube Grease Cap
- 1.99 Inch O.D.
- 1.99 Inch
- 2000 lbs Axle
- 2200 lbs Axle
- 2500 lbs Axle
- 3000 lbs Axle
- 3500 lbs Axle
- TruRyde
more information >
Continue Researching
- Q&A: What do All the Numbers on My Grease Seal Mean? What Numbers are Important?
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: How Are The Dexter Vault Bearing Protectors Measured?
- Q&A: Looking for Bearing Kit for 3,500 lb Trailer Axle
- Q&A: Availability of USA Made Bearing Kit for 3,500 lb Trailer Axle
- Q&A: Looking For Pre-Grease Hub Assembly For 2008 Bear Trailer
- Article: How To Measure And Replace Everything In Your Hub Assembly
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Bleed Your Trailer Surge Brakes
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Is It Illegal to Leave My Hitch on My Truck?