What is the Mounting Hole Spacing on Curt Class IV Hitch # 14055
Updated 06/10/2015 | Published 06/09/2015
Question:
What are is the center - to - center bolt hole measurements on this hitch?
asked by: Sam P
0
Expert Reply:
I went to our warehouse and measured Curt Hitch # 14055 to get you the mounting hole dimension you requested. The mounting hole spacing on the two flanges is 38-1/4-inches. The overall edge-to-edge spread at the two flanges is 40-inches.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- For Towing
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: How To Install Trailer Lighting Harness & Brake Controller on Ford E-350 Van With No Factory Wiring
- Q&A: Which Vehicles Will the Curt Class IV Trailer Hitch Receiver Fit
- Q&A: Parts Needed To Add 7-Way Connector To 2011 Ford E-350 Without Factory Towing Package
- Q&A: Gooseneck Hitch and Air Bags for 2025 Ram 1500 RHO
- Q&A: Are Trailer Hitch Receivers that Fit a Ford E-250 and an F-250 Interchangeable
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Recommended Trailer Wiring Harness for Ford E350 Van with 4-Pole Connector
- Q&A: Parts Needed to Install Brake Control on 2014 Ford E-350 with or without Factory Trailer Connector
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Article: 5 Tips to Confidently Choose Your Weight Distribution Hitch