Mounting Bolt Hole Spacing on Titan Hydraulic Brake Assembly Part # T4423400
Updated 05/03/2010 | Published 05/01/2010
Question:
I currently have a label on my trailer brakes that says DICO on it and some warranty wording and am wanting to repalce the whole backing plate assembly. They are 10 inch. The bolt hole spacing on this Titan assembly says 4 inch. Is this across diagonally? I think my spacing is 2 7/8 X 3 inch across the bolts not diagonally and am wondering if these wil fit. I have ordered them already so an answer ASAP would be helpful.
asked by: russell
Expert Reply:
The 4 inch bolt hole spacing is measured diagonally. This is a standard measurement for spacing on the mounting plates for the brake assemblies.
Product Page this Question was Asked From
Dexter Galphorite Free-Backing Hydraulic Trailer Brake Assembly - 10" - Right Hand - 3,750 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- RH
- 3500 lbs
- Brake Assembly
- Free Backing
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Continue Researching
- Shop: Kodiak Hydraulic Brake Hose - Straight and 90-Degree Male Fittings w/ Stainless Flares - 1.5'
- Shop: Hydraulic Flex Hose - 18" long
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Shop: Demco Hydraulic Brake Line Kit for Single Axle Trailers - Drum Brakes
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Shop: Replacement Brake Line Retainer Clip for Demco Brake Line Kits - Qty 1
- Shop: Dexter Brake Line Tee with Mounting Bracket
- Q&A: Recommended Replacement Brake Hose for Grand Design Solitude 5th Wheel
- Q&A: Difference Between the Brake Lines # 18018-SF and # BH-3MFS90FF-1-5
- Search Results: bh~3mfs90ff~1~5
- Search Results: brake tee
- Search Results: tee
- Search Results: 18018~sf
- Search Results: tjd7000
- Search Results: clip
- Search Results: trailer wire
- Q&A: Replacing/Upgrading The Suspension On A 2007 Colorado Tandem Axle 5th Wheel With LRE Suspension
- Q&A: Will the Demco Hydraulic Brake Actuator # DM72VR Replace a TDE-660 on Boat Trailer?
- Q&A: Replacement Axle, Hubs, and Brakes for a ShorLandr Dual Axle Trailer
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Recommended Replacement Brake Assemblies For Eagle Trailer Drum Brakes
- Q&A: Should Titan Model 60 Actuator be Replaced if Theres Left to Right Play on Inner Section
- Article: Parts Required to Add Electric Over Hydraulic Drum Brakes to a Trailer
- Article: How to Change the Axle on your Boat Trailer Without Leaving your Driveway
- Article: How to Measure a Boat Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Hydraulic Drum Brakes to a Trailer