Troubleshooting Powered A-Frame Trailer Jack Will Retract but Wont Extend
Question:
My father in law has a Holiday Rambler Alumi Lite travel trailer and its a 97 model. The motor will only retract and for a certain distance. There is a clicking sound inside the switch housing and when it clicks it then stops. It will not extend at all to raise the trailer tongue. You can manually raise it and it used to raise once the click inside the motor occurred. It wont do that now and will only go down or retract. This jack is only 4-5 years old. Any ideas?
asked by: Jamie O
Expert Reply:
The problem you describe sounds like the gears in the motor have some teeth that have broken. This is caused from over extending/retracting the jack. The motor can retract the jack foot because when it's retracting, the jack isn't under load.
There aren't any user replaceable parts in an A-Frame trailer jack like the # LC285318 you referred, so your best bet would be to replace the jack.
I'd recommend your Father-in-Law go with the highest capacity jack available. Overkill is good in this situation, because a jack that's rated much higher than it needs to be won't be overworked and will therefore last longer. I'd recommend going with the Bulldog # BD500199 4K capacity jack, which has a 5 year limited warranty.
Products Referenced in This Question
Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22 Inch Lift
- Bolt-On
- 1 Jack
- Bulldog
more information >
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Q&A: Can A Sway Control Kit Be Added To A B&W Tow & Stow Ball Mount
- Q&A: Replacement of Norcold 1200LRIM with Everchill # WAY44FR
- Q&A: How to Connect Wiring for Extend/Retract Switch for Lippert Electric Trailer Jack
- Q&A: Replacement Atwood Water Heater for G6A-6E
- Q&A: Compatible Drop Leg For The Lippert Power Stance Electric Trailer Jack
- Article: Trailer Wiring Diagrams
- Article: Trailer Jacks
- Q&A: Replacement Top Cover for Lippert Tongue Jack 1817941
- Article: How (and Where) to Connect an RV Propane Grill
- Article: RV Propane Troubleshooting | Common Propane Issues and How to Solve Them
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Hitch Receiver Sizes
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)