Is there Any Drilling Required When Installing a Front Mount Trailer Hitch on a 2003 Dodge Ram 2500
Published 04/24/2010
Question:
Please advise if any drilling in required for attaching this unit #31322 to a 2003 Dodge 2500 truck. Thanks in advance
asked by: Ronny
Expert Reply:
Yes. There is some drilling involved when installing the Curt Front Mount Receiver Hitch, # C31017. You will need to drill two holes on the underside of the frame. I have included a link to the installation instructions for this hitch below.
The other available front mount hitch for your vehicle is the Draw-Tite Front Hitch, # 65046. It also requires drilling into the underside of the frame. I have included the instructions and an installation video for this hitch below.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 350 lbs Vert Load
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Front Hitch that Fits 2007 Dodge Ram SLT Quad Cab
- Q&A: Which Torklift Hitch Fits 2006 Dodge Ram with Factory Hitch that is Bolted On
- Q&A: Can I Use a Torklift Supertruss Without Using a TorkLift SuperHitch
- Q&A: Recommended TorkLift SuperHitch for a 2010 Dodge Ram 3500
- Q&A: How to Use the TorkLift SuperTruss on a 2006 Dodge Ram 3500
- Q&A: Which Front Mount Receiver for 2007 Ram 3500 Will Not Require Bumper Fascia Trimming
- Q&A: Torklift SuperHitch Fit Recommendation for 2012 Ram 2500 with Factory Bolted on Trailer Hitch
- Article: Stability Control for Heavy Duty Vehicles
- Article: Types of Trailer Hitches: How and Why to Use Each
- Article: Brake Controller Installation: Starting from Scratch
- Article: Gooseneck to 5th Wheel Adapters
- Article: How to Mount a Truck Bed Camper
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)