Availability of a Soft Rubber GMC Reciever Hitch Cover for a 2003 GMC Sierra
Updated 04/12/2010 | Published 04/11/2010
Products Featured in This Question
Question:
I had a 2 GMC 2-1-728 cover for over 7 years and then it was stolen. How/where may I obtain a replacement cover with the GMC logo? The product looked and funtioned perfectly until stolen.
asked by: ron g
0
Expert Reply:
If it was a soft, rubber hitch cover like the CURT # I-728 you were looking at, it was probably made for GM and put on at the factory or distributed to dealers. I have added a link to all of our GMC hitch covers below. We may have something you like.
We always recommend using a hitch lock, like part # e98880, to deter thieves from stealing your cover.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Rubber Tube Cover for 2" Trailer Hitch Receivers
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Why Does the etrailer Trailer Hitch part # e72AR Have a Higher Towing Capacity than the Vehicle?
- Q&A: Can the Center Knockout Panel be Re-Installed After a Trailer Hitch on a 2015 Cadillac SRX
- Q&A: Will Magnum Headache Rack Fit with Pace Edwards SwitchBlade
- Q&A: Hitch and Scooter Carrier with Ramp Recommendation for 2023 Acura RDX
- Q&A: Curt or etrailer Hitch for 2026 Honda CR-V Hybrid
- Q&A: Choosing Between Curt, etrailer, and Draw-Tite Hitches for 2024 Toyota Venza LE Hybrid
- Article: How to Measure for Trailer Hitch Drop
- Article: Which Hitches are Made in the USA
- Q&A: Is There A Product That Helps Protect A Vehicles Paint From Roof Rack Feet/Towers?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: My Trailer Hitch Doesn't Fit
- Article: Anti-Rattle Devices
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com