Hole Size Needed to Install Flush Mount Grommet for Trailer Clearance, Side Marker Lights
Updated 03/20/2015 | Published 03/19/2015
Question:
Hello, What size hole do I need to cut for this grommet for a proper fit, and should I radius the corners?? Thanks
asked by: Doug
Helpful Expert Reply:
The Optronics Flush Mount Grommet for A91 and AL91 Series Trailer Clearance and Side Marker Lights # A91GB, will fit a hole that measures 2-7/8 inches across and 1-1/2 inches tall. You will want to round the corners for a snug fit. This rubber grommet gives shock mount protection that extends the life of the lamp.
I have included a video review of this part for you to check out.
Product Page this Question was Asked From
Grommet for Optronics A91, AL82, AL90, AL91, or AL191 Series Trailer Lights - Black PVC
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Grommet
- 3-5/16 Inch Long
- Rectangle
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended 5,200 lbs Timbren Axle-Less System
- Q&A: Do Thinline LED Clearance and Side Marker Lights Come With Bracket and Wiring
- Q&A: Size of Inlet and Discharge Threading on Lippert Flow Max RV Water Pump
- Q&A: Best Replacement for a Wesbar Tail Light 271594
- Q&A: Recommended 2-1/2" Long Amber Clearance or Marker Light for a Boat Trailer
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Recommended Weight Distribution System for a 7,000 lbs Big Tex 70DM Car Hauler
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Holiday 2025 | Staff Picks for Real-Life Adventures
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Article: Is It Illegal to Leave My Hitch on My Truck?