Measurements Needed for Detail K2 Universal Snowplow Skid Shoes # K2SS2600
Updated 02/09/2015 | Published 02/07/2015
Question:
What is the diameter and length of the threaded post? What is the diameter and the center to center distance of the two holes on the mounting plate?
asked by: Howard N
0
Expert Reply:
I spoke with my contact at K2 and the threaded post on the Universal Snowplow Skid Shoes, # K2SS2600, measures 1/2" in diameter with a thread length of 3-5/8". The center to center distance of the mounting holes measure 2-3/8".
expert reply by:
Leah S
0
Product Page this Question was Asked From
Replacement Skid Shoes for Detail K2 Snowplows - Qty 2
- Snow Plow Parts
- Detail K2 Plow Parts
- Skid Shoes & Runners
- Skid Shoes
- Detail K2
more information >
Continue Researching
- Shop: Replacement Skid Shoes for Detail K2 Snowplows - Qty 2
- Q&A: Replacement Skid Shoes Recommendation For Detail K2 Summit Snow Plow
- Q&A: What is the Angle of the Detail K2 Universal Snowplow Skid Shoes # K2SS2600
- Q&A: Meyer HomePlow ME53FR: Comparing Float Mode vs. Down Pressure
- Q&A: How High Does Meyer Snow Plow Lift Off The Ground? Using On Bumpy Sloped Driveway
- Q&A: Plow and Mount Recommendation for Installing K2 Detail Storm II on 2002 Ford F-150
- Q&A: Replacement Shoe Assembly With 3/4 Inch Diameter Shaft for Meyer Snowplow
- Q&A: How To Use Detail K2 Storm II Elite Snowplow On 2002 Ford F-150 2WD
- Article: Where to Position the Trailer Axle?