How Do End Caps Mount and Stay Attached to E-Track
Published 01/23/2015
Products Featured in This Question
Question:
how are these mounted to a wood floor,just wood screwed in at end of e-track or do they need bolted in????
asked by: Bill R
0
Expert Reply:
If attaching the E-track or E-Track end caps # ET8730 to a surface you would just use the appropriate hardware (screws are fine) for that surface material. Bolting them on is not required but if you wanted to use nuts and bolts you could.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- E Track
- E Track Rails
- Horizontal
- 5-1/8 Inch Wide
- 2000 lbs
- 5 Feet Long
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Q&A: Tips for Installing E-Track on a Trailer with Tube Aluminum Frame
- Q&A: Differences Between Different Brands of E-Track
- Q&A: Factory 30 Amp Fuse for Trailer Brake Control vs Auto Resetting Fuse on a Ford F-150
- Q&A: Are the Erickson Horizontal E-Tracks Strong Enough for a 5,000 lb Vehicle
- Q&A: Are There Long-Term Service Contracts To Use PingMaster Trailer Tracking Devices?
- Q&A: How Many Additional Panels Can Be Added To The Rich Solar RV Solar Charging Kit RS37VR
- Article: How to Install E-Track in 3 Easy Steps
- Article: Trailer Tire Sizing
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Hand Winches
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft