How to Install a Prodigy P2 90885 Brake Controller in a 2014 Kia Sorento

Published 12/17/2014

Products Featured in This Question

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3375)

$121.29

Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional

(2750)

$134.95

Snap Bushing Grommet - 7/16" ID, 9/16" OD

(76)

$1.30

Question:

Installing a Prodigy brake controller, where do i route the wires through the firewall?

asked by: Bernd J

Helpful Expert Reply:

To install the wires of the # ETBC7 that get run to the battery of your 2014 Kia Sorento so that you can install the Prodigy P2 Brake Controller part # 90885 you will need to look for a grommet or knockout in the firewall to route the white brake wire into the cab. If none is available, you can drill a hole on a section of the firewall where there is no obstruction on either side. You will need to drill a hole to install a grommet # SWC8055 large enough for the 3 wires that will pass through.

I attached an install video to the right that shows a # 90885 being installed in a similar vehicle that requires drilling into the firewall.

expert reply by: Jameson C