Custom Fit 2000 Ford Windstar Accessories

Hey Larry, we actually sell jacketed 7-way wiring with the part #DW04914-1 by the foot. This would allow you to have all of the 7-way circuits to the back of the trailer like you are needed. You would just need to order a quantity of this that you…

We only have one single battery box that will fit the battery size you mentioned needing. For that we have the NOCO part #329-HM426 which measures 17-7/8L x 14-5/16W x 14D Inch. Nothing we offer will fit two batteries of this size though.

Your 2000 Ford Windstar has a gross trailer weight rating of 2,000 pounds unless it has the optional trailer tow package AND 3.8 liter motor. If it has both of those features then it is rated for up to 3,500 pounds. Curt trailer hitch #13085 itself…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…