Camper Jacks Specs:
Features:
Improve the stability of your parked and leveled RV with these base pads. 7" Tall pads fit under smaller units as well as units with a higher clearance. Stack 2 pads to get 12-3/8" of height and a 3,500-lb load capacity.
More Information >Videos
for RV Jack Pads
Help Articles
for RV Jack Pads
Expert Answers
for RV Jack Pads
Based on the information I could find you are going to need the SnapPad EQ Compact Jack Pads #SP24FR4. I have included an image you can use to verify your feet do look the same to fit these pads.
view full answer...I went out to our warehouse and test fit some SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 and found that the 6" square SnapPads were a fit. If your 2022 Forest River Vibe travel trailer…
view full answer...SnapPads like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 6 Item #SP54FR6 can be taken off and on as needed so you won't have to keep replacing them every time…
view full answer...Hey Tim, thanks for reaching out! The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR have a 6,000 lb rating for each Base Pad Extreme so you're looking at a total of 36,000 lbs for this kit of 6. Ideally…
view full answer...Personally I prefer the SnapPad XTRA Jack Pads #SP54FR4 over the Stromberg Carlson #SC99MR as they have been around much longer and proven themselves to be a quality product. Both these will fit 4 jacks with a 9" round…
view full answer...You are correct that the kit part number 70161 that you mentioned from SnapPad is our #SP24FR4 so this would be the kit you'd need.
view full answer...The Clearsource Ultra RV Water Filter System w/ VirusGuard #CS87FR weighs 34.125 lbs.
view full answer...The SnapPad Prime Jack Pads #SP84FR4 are specifically designed to fit the Power Gear Leveling Systems w/ 10" Round Concave Jack Feet on your 2014 Fleetwood Bounder 34B. The Pads #SC99MR Stromberg told you to use will not fit…
view full answer...Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.
view full answer...The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4"…
view full answer...The SnapPad EQ, #SN76FR will fit 10" octagon or concave round jack feet.
view full answer...While I have no way to see exactly what leveling system you have on your 2006 Tiffin Phaeton 35DH, I was able to find information on a forum showing someone who did confirm the SnapPad HiWay 10 Jack Pads for HWH and Atwood Leveling Systems w/…
view full answer...Filter Products (2)
Contact and Help
What our customers are saying:
Definately I will order from here again if I need anything. Not only was the service fantasic, the price was over welmed dirt cheap compared to so many others on the internet. The order was very professionally packaged and delv'd. I love this place. Definately I will be a returning customer.
James
Cedar Rapids, IA