Hey Therese, I would go with a frost plug style part #ZE62FR for your 2018 Toyota RAV4 hybridas it has direct contact with the coolant in the engine which will heat up the engine quicker and also more uniform since the coolant spreads throughout the…
Hey James, yes the Kat's Heater part #KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi Outlander SE. I checked with Kat's about the location of where this needs to install and they list it as FL which means on the…
Hey George, according to Kat's Heaters, their #KH11815 cartridge style engine block heater installs into the core hole on the right side of the engine block toward the front of the motor on your 2013 Ford F-150 with the 3.5 liter ecoboost engine.…
Hello Mark, thanks for reaching out. The Kat's Heaters Custom Engine Block Heater #KH97VR is correct for your 2024 Ford F150 STX 4X4 EcoBoost 2.7L engine. I am sorry to say I do not have a PDF of the instruction I can send, but I can provide…
Hi William, welcome back! The ThermaHeat RV Holding Tank or Step Heater Pad #277-000163 will definitely help with your cold weather camping and it has been tested down to -32º F. I would also consider bringing along something like sheets of…
Hello Richard, thanks for reaching out. Yes, the Replacement Plastic Check Valve for B&B Molders City Water Inlet #BM98GR will indeed work with the B&B Nautilus P4 RV Water Control Panel. The check valve works with all of the B&B panels,…
Hey Wes, I’d avoid it. All of the battery heaters we carry, such as the 50w #ZE77FR, 80w #ZE87FR, and 160w #ZE27FR Zerostart pads, are not recommended for lithium-ion batteries because they heat too directly on the case. Lithium cells need…
Hey James! For a 2020 RAV4 I'm not entirely sure if that is too much or not. Does it feel like your braking is off when you carry everything? Are the headlights tilting up from the rear sag? Are you bottoming out? If any of these things are true…
Christopher, I did some research, and it looks like it should be by the exhaust on the driver's side of the engine, underneath the driver's side door. Immediately behind the driver side exhaust header there is a factory designed hole for the…
I confirmed with Kat's Heaters that the port location for the Custom Fit Engine Block Heater #KH11815 on your 2018 Ford F-150 with the 3.5L V6 EcoBoost engine is on the right front of the block. I went ahead and attached a diagram that shows this…
The Agricultural Trailer Hub Assembly #AH15450ECOMP is what you are looking for. It uses a Inner Bearing #LM67048 which has an inner diameter of 1.250" and an Outer Bearing #LM11949 with an inner diameter of .750". You can verify that the…
Hey David! As long as you don't go over the 3,000 lb capacity I recommend the RoadActive Suspension Custom Leaf Spring Enhancement Kit #RAS3611-HD. The RAS is nice because it won't have a negative impact on your unloaded ride quality. It can…
