Grille Guards Specs:
Features:
...Custom-fit bull bar guards your vehicle's front end against dents and scratches Skid plate offers additional protection for bumper Tight fit provides maximum ground clearance Integr...
Installation Notes:
No drilling required for installation
Product may partially cover the license plate. If needed, use license plate relocator 32-0055, sold separately
Product will interfere with any front end sensors or cameras, if equipped
More Information >Grille Guards Specs:
Features:
...Custom-fit bull bar with 8-sided design provides a modern look and helps protect your vehicle's front end Mounts close to bumper for maximum ground clearance 28" Tra...
Installation Notes:
No drilling required for installation
More Information >Grille Guards Specs:
Features:
...Custom-fit bull bar with 8-sided design provides a modern look and helps protect your vehicle's front end Mounts close to bumper for maximum ground clearance (2) 2" L...
Installation Notes:
No drilling required for installation
More Information >Videos
for Grille Guards
Help Articles
for Grille Guards
Expert Answers
for Grille Guards
It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…
view full answer...Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…
view full answer...I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine,…
view full answer...The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack…
view full answer...Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque…
view full answer...The best way to determine the weight capacity of your leaf springs would be to check the weight rating of the axle on your trailer. The trailer will have a plate or sticker on it that will list the VIN number. The weight rating of the axle should…
view full answer...I agree, the bag for the NOCO Boost X Jump Starter #NOC88VR is a nice way to keep everything together but it definitely lacks in the protective department. To keep your Boost X Jump Starter safer…
view full answer...Pace Edwards has two confirmed fitting Switchblade covers for your 2024 Chevy Silverado 3500 DRW 8' bed; part #PE87CV, which is an aluminum and vinyl mix and part #PE77CV,…
view full answer...There is a trailer hitch receiver as well as a 4-way wiring harness that fit your 2022 Jeep Grand Cherokee WL; that said, we don't have any way to reference a VIN so…
view full answer...The hub/drum you sent in a picture of is a Lippert 8,000 lb axle hub with an 8 on 6-1/2 inch bolt pattern designed for oil-bath applications. The correct replacement then is the #8-285-10UC3-A.
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...The Replacement Hardware Kit #AABRKT-5056 will fit the Aries Pro Series Grille Guard #AAP5056. This is the upgraded version of the Grille Guard #AA5056 which uses the same install hardware to attach to a truck.
view full answer...