Vehicle Style: Crew Cab - 8 Foot Bed - 6.7L I6 Diesel Engine Change
Exhaust Systems Specs:
MagnaFlow Exhaust Systems Features:
...included Custom fit for your vehicle Made in the USA Specs: Tubing diameter: 5" Inlet pipe diameter: 4" Tip dimensions: 6" diameter x 13" long Number of tips: 1 Exhaust system: single...
More Information >Exhaust Systems Specs:
MagnaFlow Exhaust Systems Features:
...stainless steel Simple installation using factory mounting points Clamps and hangers included Custom fit for your vehicle Made in the USA Specs: Tubing diameter: 5" Tip dimensions: 6" diameter x...
More Information >Videos
for Exhaust Systems
Help Articles
for Exhaust Systems
Expert Answers
for Exhaust Systems
When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in…
view full answer...According to my research, your 92865A-1 hub/drum has a 25580 inner and an 14125A outer bearing and a 8 on 6-1/2 inch lug pattern, as does the AxleTek #AKHD-865-7-2-K hub drum you referenced. The #AKHD-865-7-2-K would be an acceptable replacement…
view full answer...We have toppers that'll work for 2 of your 3 sliders. For your 12 foot 9-1/2 slide, use #LCV000168109 which is designed for slides measuring between 152-157 inches wide. The longest topper we offer is for slides…
view full answer...If you check out the picture I attached you can see that the roller and slide out awning assembly of the Solera RV Slide-Out Awning #LCV000435661 actually will sit below the awning rail so your setup having a tight clearance between the rail and…
view full answer...Hi Bruce, To lift your trailer we'll first need to check of the suspension and see if you have torsion axles or a leaf spring suspension. If you have torsion axles then I'll need…
view full answer...Please note the attached instructions. The Lippert Anti-Billowing Kit for Solera Slide Topper Awnings, #LC78FR should be installed on the end of the awning that is closest to the front of the unit. 1. Make sure awning is fully retracted. 2. Place…
view full answer...You have a good eye as the black tubing sections are plastic for the Camco Gen-Turi RV Generator Exhaust System #CAM44461. It's just the curved pipe section that is made out of stainless steel.
view full answer...Hi Chris; your 2022 Ford Expedition will have a Normally Closed application, and it is possible when installing the Roadmaster Brake-Lite Relay Kit #RM-88400 that you'll need Hy-Power Diode #RM-790. I…
view full answer...The 2022 Ford F-150 (Non-Hybrid) requires special diodes for the flat-tow wiring harness. If you're not using these special diodes then you could run into issues like you described. The correct ones for this vehicle…
view full answer...For vehicles where it's nearly impossible to find a dedicated stop light circuit the Roadmaster Universal Stop Light Switch Kit #RM-751000 is a great solution. Basically it gets power from your battery and has…
view full answer...Ultimately you do not need a converter as you can wire the tail lights on your 2022 Ford F-150 to operate as brake and turn signals just like the lights on your motorhome. You will need to use the Roadmaster Universal Wiring Kit with Smart Diodes…
view full answer...I advise measuring the two spindles that you have and making sure that the parts that you are wanting to interchange will be a compatible fit. I have included a photo that shows where where to take these measurements on your exiting spindles. These…
view full answer...