Videos
for Tree Saver Straps
Help Articles
for Tree Saver Straps
Expert Answers
for Tree Saver Straps
That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
view full answer...I am far from an expert on snowmobiles but one would have to think such a large truck with the correct tires and chains would be able to make it through up to 2' of snow assuming you have clearance on the vehicle. In regards to the type of tire…
view full answer...Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…
view full answer...Since tire chain fits are pretty specific and there's such a wide range of tire sizes there ends up being a bit of overlap for some sets of chains. This is the case for the two Titan chains you mentioned of #TC2327 and #TC2533 mostly but there…
view full answer...Choosing the correct replacement cable and pin for your 20005 and 20014 Hopkins breakaway switches will depend on the style of key that they accept. Hopkins changed the style of keys that their breakaway switches accept, but kept the part numbers the…
view full answer...For The ComeUp Seal Gen2 Off-Road Winch - Wireless Remote - Synthetic Rope - Hawse Fairlead - 16,500 pounds #CU295660 per the manufacturer to run a 20 foot run of cable they would recommend 00 (2/0) AWG.
view full answer...First you would need an engine oil cooler kit. I recommend #D15502 because it comes with multiple thread types and has the proper O-ring size for a V-6 Toyota motor. The sandwich adapter included is thermostatic so a separate thermostat is not…
view full answer...Yes, it is! The Gen-Y Hitch Pin and Clip for 2" Hitches item #325-GH-096 will work with all 2" receiver hitches and is rated for the extra weight of a class IV or V hitch.
view full answer...The correct hub/drum for a Dexter 4,000 Lb Axle is the Dexter Trailer Hub and Drum Assembly part #K08-426-91. Then for the brakes, you can use the Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-468-469. The hubs/drums for a 3,500 lb axle are…
view full answer...The Gen-Y Pin and Clips are available as part #325-GH-096 for a 2" hitch and part #325-GH-099 for a 2-1/2" hitch, but the clips are not available separately. We do have standard pins, like the Curt #C21600 which fits both options, but none…
view full answer...According to TorkLift, the TorkLift PowerArmor Solar Single Locking Battery Box #TLA7720RS measures 17-3/4" long x 8-3/16" wide x 12-7/16" tall. This battery box also includes a solar panel that also provides power for stored…
view full answer...Both the Draw-Tite Max-Frame Trailer Hitch Receiver #75673 and the Curt Trailer Hitch Receiver #C13206 will require drilling to install on your 2017 Subaru Outback Wagon. It is only a 1-1/8" access hole though so it is pretty minimal. The reason…
view full answer...