Hey Jesse, cool name! That's definitely a custom project, and there isn't a single off-the-shelf kit that'll give you everything you need. For a lift-up wall that's around 10' x 6', you're looking at building the door and…
Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…
Hey Craig. Had to go measure this myself out in our warehouse, I see we don't have this listed. That opening is large enough for a 1" thick panel. What are you looking to panel?
Hey Jeff, thanks for reaching out. I just went out to our warehouse and measured the P&F Products J-Channel Rail for Enclosed Trailers #PF26FR. The interior dimension of the J-channel I measured at 0.17". What thickness plexiglass were you…
Hey Doug, welcome back! Yes, since you have a Lippert 4,000 lb axle the replacement Lippert hub/drum kit part #LC72DX would be correct for a replacement. Are you looking to have a spare on hand or is yours currently in need of replacing?
Thanks for reaching out, Ron. I was able to look into your axle using the information you provided, so that definitely helped identify the right ones. For your setup, the correct Timken bearings would be #TMK44FR and #TMK34FR. Those will match up…
Hey Matthew! Thanks for the axle tag picture. Even though the capacity is 3,000 lbs it will still use the #84 spindle. The LCI35 is a 3,500 lb model designation so the Lippert Brake Drum and Hub Kit #LC72DX will work as a replacement. What kind of…
Appreciate the photos, and yes, the trim you asked about does look to be exactly what you are needing: - Even Rub Rail Trim for Enclosed Trailer - 1-1/2" Tall x 1/8" Deep - Aluminum #36284-955 This trim is 93-1/2" long, so if…
It sure is Chris and thanks for the information! The Lippert Brake Drum and Hub Kit item #LC72DX is designed for 3,500 lbs axles and has a 5 on 4-1/2 lug nut pattern. This hub is sold individually. It comes ready to be installed with pregreased…
Hey Steve, the Rubber Door/Hatch Seal for RV and Trailers #SR98ZR comes with the adhesive needed to install it so really you just need to clean the surface you plan to install it on and it would be ready to be put on!
Hey Greg, welcome back! So this is a great question but for a Dexter 3,500-lb axle, the castle/spindle nut does not stay torqued to a specific ft-lb value. Dexter's official bearing-adjustment procedure is while rotating the hub, tighten the…
Filters
