Hey Bob, thanks for reaching out, and good question. For that setup, as long as the tray is properly secured in the portion that is touching the floor, it will be just fine. It might be a bit more difficult to install since you can't secure the…
Hi Chuck! The MORryde RV Cargo Slide Tray - 72" x 26" - 1 Way Slide - 60 Percent Extension - 800 lbs #MR67FR sits 1.6 inches above the floor you mount it on. If you want or need it to be a bit higher off the floor, you can also grab the…
Hey Ethan. From the mounting point of your RV to the top of the carpeted base is going to be 2.31" on the MORryde RV Cargo Slide Tray item #MR78RV. The bottom of the tray sits 1.57" above the mounting point on your RV and the wooden base is…
You can go with a listed 29" model of the MORryde RV Cargo Sliding Tray as its actual width is 28-3/4". Please note the attached image showing dimensions of width. We have the #MR69FR that is 90" in length by 29" wide and has a 2…
Hi Glen, It will depend on what the GVWR (gross vehicle weight rating) is of your trailer to determine which B&W 5th wheel to gooseneck adapter will work best for you. Fifth wheels and gooseneck trailers go off of pin weight instead of tongue…
While there is no visual guide available to determine the sizing for the MORryde sliding cargo trays like the #MR38FR, it really depends on the height, length, and depth of your RV compartments opening. The #MR38FR that you were looking at, for…
Hey Arthur, The dimensions I'm seeing for a 3500watt Predator Generator show it being 22.8" L x 17.3" W x 20" T so if you're wanting it to sit with the 17.3" side facing out the closest fit would be the MORryde RV Cargo…
Hey Paul! The PullRite SuperGlide #PUL43RR (2714) and #PUL73RR (2914) do weigh the same. The main difference is the capacity, which is going to come from the base of the 5th wheel hitch. Since your 2027 Keystone Cougar 316RLS has a GVWR of 12,900 lbs…
The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…
Hello again Bob, On the MORryde RV Cargo Slide Tray - 90" x 29" - 2 Way Slide - 60 Percent Extension - 800 lbs #MR69FR the overall dimensions are 90" long x 29" wide x 6-5/8" tall, the actual tray dimensions are 88-1/4"…
Hey Laura, as long as the sizes match like you've noted that they do the Furrion #FR77AD would fit and work great in place of what you have now! With RV microwaves like this there really isn't more to it than that. How did you like the…
Very helpful/friendly Customer Service. Competitive Pricing. Shipping was Fast.
John
Mankato, MN
26 Inch Wide RV Cargo Slides with 80 Percent Extension
Sturdy and ready for real use, these 26 inch wide RV cargo slides give you the reach of an 80 percent extension for easy access in RV bays or a pickup bed. Installation is simple, though they're somewhat heavy, so plan on two people to place one, and you can bolt or rivet it down to keep camping gear organized for an outdoor kitchen or basement storage.
Have two people for placement; it's sturdy and heavy. A 72 x 26 two-way, 80 percent extension, 500 lb version weighs 110-lbs with hardware and mounting rails, roughly 100-lbs by itself. In a truck bed, it can be bolted with the included hardware or even rivets—just ensure the fasteners hold it securely and safely in place.
It extends 80 percent of its length. If you need to clear a 30 inch slide and a 20 inch refrigerator depth, you need at least 50 inches of travel; a 72 inch tray extends 57-1/2 inches. Confirm your cargo compartment depth matches the tray length you choose.
The listed 26 inch dimension is the external width. Usable width is 23-3/4 inches, and the sliding section is 22-7/8 inches. For a 72 inch length, usable length is 69-1/2 inches. Check your gear sizes against the usable dimensions, not just the overall size.
Yes. The portion that slides in and out is 22-7/8 inches wide, so a 25 inch opening works. Plan for a minimum just over 22-7/8 inches; 23 inches is an easy number to use. Measure the narrowest point of the opening, including trim.
Filters
