Videos
for Marine Power
Help Articles
for Marine Power
Expert Answers
for Marine Power
No, the SmartPlug RV Power Cord Adapter #SM93VR does not provide power to both legs. It only provides power to one side/leg of the 50amp service.
view full answer...Yes, it's very common that most campsites only offer 30 amp service and you would not have an issue still using your SurgeMinder Surge Protector and Circuit Tester - 50 Amps #SU99SR to protect the trailer along with an adapter to connect to…
view full answer...In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along…
view full answer...Based on the available information for your 2022 Airstream Flying Cloud 30FB it looks like you have Dexter #11 Torflex axles. Assuming that is accurate, you need the Torflex Lift Kit - Tandem Axle - 2-7/8" Lift #K71-724-02. I recommend verifying…
view full answer...By king pin sleeve I believe you are referring to a gooseneck to 5th wheel coupler adapter, and there is one for a square inner tube: - Gooseneck to 5th Wheel Trailer Coupler Adapter - Inner Tube - Square - 25,000 lbs #KPG5-Q25-IP The #KPG5-Q25-IP…
view full answer...I do see the 2024 Ford Transit 350 is unchanged from the 2023 model year so there should be no reason the SumoSprings Solo Custom Helper Springs #SSR-121-54. When I reached out to SumoSprings they have not yet been able to verify fitment yet as they…
view full answer...The Hydrastar Vented Marine Electric Over Hydraulic Actuator for Disc Brakes #HS481-8067 is designed to be completely plug-and-play so the female end of the 7-way would need to connect to the 7-way cable that's already installed on the trailer…
view full answer...Kenny, those bolts for the B&W Companion 5th Wheel Trailer Hitch #BWRVK3500-5W should be torqued to 40 ft. lbs. Also, the pivot arms would need to be torqued to 80 ft. lbs, the draw down bolt should be tighten to 60 ft.lbs and the arms should be…
view full answer...It would not, the cap would not fit over the male metal tabs. Instead you would want the part #F30COVSS to use with the part #F30MLPSY .
view full answer...Yes, all you'll need to do is disconnect the three wires running from the converter section in your Progressive Dynamics 4100 #PD4135K from the AC distribution panel (circuit breaker, ground bus bar, neutral bus bar). This will cut the power…
view full answer...Thanks for the photos they were very helpful, and the answer to your question is yes, the Power Grip 90-Degree Locking RV/Marine Power Cord with Handle - 50 Amps #CAM55572 will abslolutlely work for what you are trying to do. There isn't a cord…
view full answer...I checked with SmartPlug and they stated that the RV Power Cord part #SM36FR that you referenced has 10 gauge wires and the core is 100 percent copper.
view full answer...