Boat Motor Accessories - LubriMatic

Hey Kris, the Dutton Lainson winch part #DL15440 does not come with a strap so you will need to order one with it. The part #DL24250 will work great with this winch as it is correct width, is 25 feet in length, and has a capacity of 3,700 lb WLL and…

Thanks for reaching out Greg, we get this question from time to time. At this time, we don’t offer any tire and wheel packages in a 5 on 4.25" bolt pattern. The main reason is this bolt pattern's typically is found on a passenger vehicle…

I do not have any exact sizes on the parts used for the Dilly trailer, but fortunately all it takes to figure out the correct parts is a bit of measuring. If you would like to send me the following information, I'll be happy to recommend an axle…

Hey Robert, yes the Kodiak disc brake calipers part #KDBC225DAC that you referenced will replace the Tie Down calipers you have now 46304, they can be used as a left or right hand caliper and does come with ceramic brake pads. If you ever needed…

Jason, you only need one Hub Saver per wheel. Since they're sold in a pack of two, one package is enough for a single-axle trailer with two hubs. If you have a tandem-axle trailer, you'll need two packs to cover all four wheels. The Hub Saver…

It looks like you have the CE Smith boat bunks part #CE27600 in the picture you sent in so then for replacement upright brackets you'd want the #CE27609PG and you'd be set.

Hey Michael, yes the hitches from the 2025 Sprinter fits also fit the 2026 models like the etrailer #e82TR. We haven't carried them over quite yet in our fitguide but we will be soon. What are you planning on using the hitch for?

Hey Jeff, Depending on how much clearance you need from that tailgate is going to determine what kind of hitch extender you will need. Assuming you just have a factory 2" hitch receiver on your Ram you could go with the hitch extender #e48YR…

Hi Richard; we have no way of knowing what mounting bracket/brakes are on your Load Rite trailer. If you have Dexter/Tie Down Engineering disc brakes with a 9.6" rotor there is a good chance the #DX89UR will fit. However, it is probably best to…

For a disc brake model with an electric reverse lockout solenoid you can use #099-175-20.

The Dexter Brake Actuator part #099-175-20 replaced the Titan 60 that has a master cylinder with a fitting at the end. The fitting is a 3/16 inverted flare where the brake lines connect to. You do not need an extra fitting when you use the actuator.…

Hey, Lance. The direction the springs are in doesn't matter. They can be to the front or to the rear of the axle and will perform the same either way. What kind of trailer are you working on?