ATV ramps - CargoSmart

Hey Greg! Where did your Stromberg Carlson Base Pad Extreme #SC53VR crack? The Andersen Trailer Jack Block #AN39VR is a good alternative. It has the same 6,000 lb capacity and the design is a little more basic/straightforward which makes it less…

There is a potential solution for you but the Arched Loading Ramp Set #288-07432-2 you referenced would not work with your 2017 GMC Sierra 2500HD with a 39-1/2 inch bed height. Instead, you may be able to use the Erickson Arched, Aluminum Loading…

Hey Michael! The etrailer Electric Trailer Jack w/ 7-Way #e74GV you were looking at will definitely have enough lift for your Coleman 13R. This is a great option if you just want to power the jack off the 7-way on your vehicle instead of running it…

The length of the HappiJack Swing-Out Extender Bracket #HJ54FR is 16 inches, the width is 5 inches, and the distance between the mounting holes is 7-1/2 inches. I went ahead and attached a diagram of the dimensions to this question as well as a video…

It won't be an issue. Since the combined weight of the #288-07452-2 is 1500 pounds, the ramps are designed to withstand the 1,450 pounds of your mower. However, if you are worried about it, you can always go with the #288-07474-2 which has a…

I've attached the wiring diagram for you to check out, but it sounds like the compressor for your #AL57289 is not getting power. The wiring harness has an ignition wire which if not connected to an ignition source, will not wake up the compressor…

Hey Chris, the good news is yes, the Roadmaster Direct-Connect Base Plate Kit #RM-524431-5 that you have for your 2020 Ford F-150 Raptor will also work for your 2025 Ford F-150 Raptor. As of right now it does not look like we have an install kit for…

Hello Craig, They changed the frame on the Volkswagen Tiguan for the 2025 model, so the one from before that you were able to move from car to car will no longer fit. We use the picture from the 2024 for the pre-order because it will look somewhat…

Hey Chris! The black wire on the etrailer Electric Trailer Jack #e23ZV is just a ground wire. Realistically you can ground it however you want but I would say running it to the frame with a self-tapping screw as indicated in the instructions is the…

For a Lippert 4,400 lb trailer axle the correct bearing kit is the part #BK2-100 which includes inner bearing #L68149, inner race #L68111, outer bearing #L44649, outer race #L44610, grease seal #58846, a cotter pin and a tang washer.

I attached a picture that has about every dimension you could want for the part #BD500217. The overall length is 17 inches and the diameter of the screw is 1-1/4 inches.

That's hard to say but the ramps part #EM07473 are 84 inches long. So what you can do to get an idea is find a tape measure that can go out 84 inches and set one end of it at the rear tailgate edge when at that length and the other on the ground.…