1984 Oldsmobile Delta 88 Catalytic Converters

Lippert Components purchased the Everchill line so we finally have some manufacturer support for the Everchill RV Refrigerator w/ Freezer Drawer #WAY44FR. I've attached the manual below to help you out.

The clip that you are referring to that holds the 7-way plug to the socket is typically found on the connector which is why the #HM40940 does not come with it. I wish we sold that piece by itself but only way to get it is to go with a new harness…

From what I have found, the ALKO hub and drum assembly you have is for 7,000 lb axles. I believe the Dexter Trailer Hub and Drum Assembly for 5,200-lb to 7,000-lb Axles - 12" - 8 on 6-1/2 #8-219-4UC3 will work as a replacement. This has the same…

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

The Shackle Strap part #TRSL350 comes as a single strap. There should be 2 shackle straps per spring on a single axle trailer. You would need to order 4 of the part #TRSL350 for a single axle.

The Inno Box 2020 Rooftop Cargo Box #IN86FR will fit as long as you have the required 24"-39" crossbar spread. You will need to measure to be sure. Also yes, this will fit on the Inno Aero Crossbars #INXB130-2.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To flat tow your 2010 Chevy Silverado 1500 you will need to first start with a base plate kit. For that the most popular option is the Roadmaster #3154-3. In addition to the base plates, you will also need a compatible tow bar, safety cables,…

You'll need to do some slight measuring to ensure the fit of the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV on your 4WD 2022 Ford F-350 FX4 dually. Just measure from the top of the rear axle to the top of the jounce…

Since you already have a factory 4-way flat on your 1996 Ford F-350 you will need the Adapter 4-Pole to 7-Pole #37185. This will plug into your factory 4-way and the rest of the wiring will have to be spliced into your factory wiring as I do not see…

The UFP 34044 is basically the Dexter DX7.5L A-60 part #DX89FR. The second number you mentioned is actually a phone number. But the #DX89FR would be an exact replacement for what you have.

Both part numbers you referenced are confirmed catalytic converters for your 2003 Toyota Corolla. The difference is that the part #MF49461 is a higher grade converter. It is part of the OEM Grade line of converters from Magnaflow. OEM Grade…