2007 Honda Ridgeline Bug Shield

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Erik, the leg kit you are looking for is the part #CU53FR. This will convert your Curt A20 to a version of the hitch that will fit the OEM rail kit of your 2025 Chevy Silverado 2500 directly.

Hey Steve, yes the WeatherTech hood protector part #WT37RX that fits your 2025 Honda Pilot will survive going through automatic car washes that have brushes.

Hey Scott! The #TL86NR is designed to fit the 6-3/4' bed. Do you have running boards? What kind of hitch do you have? If you have no running boards or cab length running boards with a factory or TorkLift hitch you need the #TL94PR. If you have no…

Hey Vince, yes the Curt Q25 fixed hitch part #C97FR can be used in the bed of your 2025 Chevy Silverado 3500 with OEM pucks. This is a fixed hitch which means it doesn't have a way to gain additional turning clearance like what is normally needed…

Hey Dan! What are you experiencing when you tow your trailers? If you're getting rear sag with a little bit of body roll I would get the Coil SumoSprings #CSS-1168R for the additional suspension support. If you're primarily getting a lot of…

Hey Jason, welcome back. For a 2025 Toyota RAV4 Hybrid, I recommend the TowSmart Trailer Hitch item #TS42VR. This class III hitch with a 2" receiver is custom fit and is compatible with all models of the 2025 RAV4 including the hybrid and PHEV.…

Hey Fred, The Curt Q20 hitch configuration that fits your 2025 GMC Sierra 3500 with the OEM pucks and the leg kit part #CU53FR is the #C57FR and it has a height range of 13-17 inches. This will fit the pucks you have in your truck as the short bed…

There are a few differences between the BAK Revolver X2 and X4s tonneau covers. The X4s is the newest cover available by BAK, so it includes a new matte black finish on all sides, whereas the X2 will be matte on the top, and then silver on the…

Hello Rich, thanks for reaching out. The WeatherTech Custom Fit Hood Protector #WT56TK attaches using screws that attach to the bottom of the hood. My associate here has one on his Highlander, so I went and took a picture showing how it attaches. I…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

Is the battery of the breakaway kit charged? Does your tow vehicle have a brake controller installed?