Most Popular Backup Camera for 2018 GMC Sierra 3500

The installation was fairly easy. The trailer came prepped for the rear camera so, it was attached and linked. The side cameras involved a little work due to being close to the pass-through doors. They went on with a bit of cutting of the trailer skin. The problem is the right side trailer camera is reading that it's the left side and visa versa for the right. They are both installed correctly, facing back and the pairing button on the bottom. Also when the two side cameras paired they caused the rear camera to unpair. I re-paired the rear and now the right side ( left camera ) is unpaired. I've emailed Furrion for answers to my situation.

Have not been out on the road yet but the install was easy even for a novice like me. My reflection 5th wheel was prewired so it was a plug and play for the rear camera. For the side cameras I used the two screws from the previous light. I put both screws in the top holes, (one behind the camera) as that seemed to secure it better then bothe screws not behind the camera. Instructions were a bit limited(or I didn't read them) on the side camera sync but I pressed enough buttons to figure it out. Picture looks great. Do watch for obstructions such as awning supports which will limit view. I also used silicone to keep the water out.

I came with a 5" screen the last on in the kit came with 7" not happy with this order.

Excelente producto, facil de instalar y envio seguro y rapido, no requieres un técnico, lo puedes hacer tu mismo con poca herramienta, 2 horas en instalacion. (Excellent product, easy to install and safe and fast shipping, you do not require a technician, you can do it yourself with a few tools, 2 hours to install.)

Have not tested this on the road, so this covers installation. Instructions are clear and easy to follow, I was not clear about what to do with the trigger wire when you are retro fitting to an older RV, the FAQ on etrailer had the info, thanks for that. Installed this on a 2000 Lance camper sitting on a 1978 Ford F250 The side cameras were very easy to install, the backup camera required a little bit on modification to the camper. I did not like the monitor install options so did some simple modifications to the stand so I could use ram-mounts. Final setup is amazing

Pretty good. Easy to install. Directions could be better, however. One major annoyance is neither of the two mounting stations do a good job of holding the display.

Gives be great visibly on both sides and blind spots. Used the rear camera to watch my TOAD.

I purchased this camera for my 2022 Winnebago Micro Mini. I should say this is the second camera a bought, My Micro Mini was prewired for a camera and had a connector to plug in and I had incorrectly purchased the wrong the camera that had to be hardwired. A simple call to etrailer and they sent me a new camera and provided shipping label to send back unit I mistakenly ordered. I got the new camera, mounted it and plugged right in, installation took less than 10 minutes. Only issue I had was the truck lights have to be on for the camera to work, which turns out I like because I know my light should be working if my camera is on. Camera works great for seeing cars behind you or when passing cars. Did discover that monitor/screen is obnoxious when mounted on dash and the motion on the screen when driving, I had to move the monitor/screen down on the council and only look at it when I'm passing cars and such, don't need all the time. Overall I give this 10 out of 10 rating.

The Voyager was easy to install and provides a decent camera image. The 7- inch display is substantial in size and the suction cup mount leaves you with only the windshield as a mounting point. In my case, with a 2024 Toyota Tundra, the display blocks the view out the windshield no matter where I place the suction cup mount. It would be far better to provide a standard size 'ball and socket' that could attach to other mounting options such as a weighted bag mount. As it is, the Voyager ball and socket is a large, non-standard mount that excludes using other mounts. They should take a look at Garmin, who has standardized mounts. If this unit offered a better mount so that I could place it in the tray on top of the dashboard, or elsewhere, I'd give five stars. Anyway, I'll keep it and cook up my own mount adapter.

We purchased this camera to help get our rv in and out of a tight storage spot and to see behind the trailer while driving. The tow vehicle is much narrower than the trailer making it impossible to see behind the trailer even with extended side mirrors. This system allowed me to avoid cutting off any vehicles approaching from behind when changing lanes. The display was installed on top of the dash. The camera replaced the built in furion mount on the trailer. Due to short time, the cord was run externally. This kit is meant for a motorized rv, not a trailer. After opening the kit I realized I had to buy an extension cord to run from the display adapter cable to the rear of the tow vehicle. Then the cable could be disconnected at the trailer hitch. When using the system, the display is good, but very narrow field of view, vertically. So I can either see traffic or see the rear of the trailer for backing up. A second camera would seem to be the best solution but not my favorite one. The mic and audio did not work well. I could not hear my wife, but hilariously, I could hear cars at the rear. Might just be me ... I only ever used channel 2 which I thought was the only channel carrying audio. HINT: adjusting the volume was extremely painful until my wife figured out to adjust it on another unused channel. The brightness could not be adjusted making it bright at night. I aimed the display downwards to help. The instructions seem sufficient and are very brief. The system operates like a prototype rather than a finished model. But it does show the camera even with the display on the dash in the hot sun. We used it for the entire 3300 mile trip. It was on the entire time we were driving. I removed the display after returning home with my fingers, no tools. Overall, I am ok with the system. I still think it was the best purchase for me considering the cost of other systems and the wireless connection problems of other systems except perhaps for the most expensive. Note, I read someplace that some states may not allow a display to be on where the driver can see it while driving.

Ez to install—plug and play. Complete wired system—much more dependable than wireless and a lot less fussy to use. I cable tied the wires under a 37’ Class A. Plenty of wire. Used the old wire as fish tape. Old system was 17 years old. Compared to that, this one is high tech but reasonably priced. The flat screen is lightweight and it was EZ to cut the dash to fit. Very happy with this backup camera. Good clarity. In reverse, grid lines appear. It’s good. BTW The pics of the monitor on the box is the old monitor which is huge and heavy compared to this flat screen.

Install was super easy (my camper had a wired plug in place when I bought it). Connecting the screen to the camera was simple. The camera worked flawlessly after my install and initial connection for a year on the road. The only issue I had was keeping the suction strong enough on the windshield to hold the screen in place.

The camera was easy to install on the camper with the pre wired connection, pairing was a little tricky, instructions could have been a little more detailed. The YouTube videos resolved that issue. The monitor was clear and any display adjustments were easy. Sorry no photos or video.