Hi Jesse; the only reason I can really think of is your bolt pattern. If you have a 1621 bolt pattern there is no reason why you wouldn't be able to use the lower rated Curt Flex Air 5th Wheel Pin Box - Lippert 1621 - 18,000 lbs # LC328492 you were looking at. If you have something like a Lippert Rhino the 21k # LC65VR is the only capacity available. The higher capacity will be fine, pin boxes are usually over by quite a bit anyway, but if there is a lower capacity option that can handle... view full answer...
Hey Jarvis, the Lippert Tailgate Storage System # LC404069 would install using either the Lippert Tailgate Storage System Mounting Kit # LC432223 or # LC432336 using the included brackets and hardware.
To answer your second question, the tailgate storage system # LC432223 would install under the bumper and # LC432336 would install over the bumper. view full answer...
Hey Shawn, so for wood bunks we have vertical bunks like the part # HP52FR which would attach to the crossmembers of the trailer frame. view full answer...
Hey Rick! If you aren't concerned about the appearance of the wheel since it is a spare you can use the Karrier # AM32545 (if you have a 5 on 4-1/2 bolt pattern) or the # KE64WV (if you have a 6 on 5-1/2 bolt pattern). If you just want the wheel the # AM20545 (5 on 4-1/2) or # DEX49FR (6 on 5-1/2) will also work.
If you're trying to match your current wheels, or find something similar, I would be happy to see what we have if you can send me a picture of the wheels on your trailer. view full answer...
The 7K Dexter Nev-R-Adjust Electric Trailer Brakes, which comes in a set with both the Left Hand and Right Hand assemblies included as part # 23-464-465, can certainly be installed on your 6K axle assuming its 5 bolt pattern matches your existing flanges. In terms of size and bolt pattern these are indeed interchangeable with the Dexter 6K # 23-458-459.
You are correct that the difference between the two sets just comes in their braking strength since they are meant to stop different... view full answer...
Good question, Ron!
The Yakima Landing Pad 1 # Y00221 you have will indeed work with the Yakima 72" HD Tracks # Y84MR. With that said, the weight capacity will be lower than with the Landing Pad 26 # Y75ZR and HD Bar combo. It will only have a 165 lb. dynamic weight capacity for the 2-bar setup instead of the 220 lb. with LP 26 + HD Bar. As long as that weight capacity works for you, you are good to go!
Speaking of which, what are you planning on using it for? view full answer...
Hi Reeve,
In order to find the correct replacement plug I'd need a bit more information on your wheel. Can you send me a picture of one of the other wheels so I can see the design, the tire size code on the sidewall of the tire, the diameter of the pilot hole for the wheel, and the bolt pattern of the wheel? view full answer...
Hey Donny, welcome back! The # ASR1200S04 uses a 3,500 lb axle bearing combination so for oil bath disc brakes you can use the Kodiak # KOD77FR. Then for the 7k # TASR7KS02 you can use the Kodiak # KOD33FR. Let me know if you need anything else. view full answer...
Hey Wayne, to replace your WF-9865 converter you have I recommend the Progressive Dynamics 9300 Series RV Converter Charger # PD79RR. This converter is compatible with lead acid, AGM, and LiFePO4 batteries and has a 60 amp converter rating. It installs the same way so this will be an easy swap out of your current converter that won't require any additional changes. view full answer...
Hey Dave, welcome back! The Furrion Vision S+ Wireless RV Observation System # FR74AD you looked at is the one I recommend. This is the latest camera from Furrion and includes marker light cameras. The camera monitor lets you watch 3 angles at once so you also get a nice, clear view out on the road. If you want something less extensive that only includes the backup camera then the # FR57AD is also available.
Do you have any big trips planned with your 5th wheel this summer? view full answer...
Hey Suzette. I wasn't able to get any information off of that part number. If you could get me some dimensions off of that light I can look and see if we have a comparable replacement.
You can add this information and any other questions you have where it says Reply to Jerred H and I'll be happy to answer them. view full answer...
Hey Michael! Ladder racks like the Stromberg Carlson RV Exterior Ladder # LA-401 are a universal fit. This measures 99-1/2 tall x 12" wide and has trimmable legs so you can size it perfectly on your Highland Ridge Olympia Sport 19BH. If you need anything else don't hesitate to reach out in the comments below. view full answer...
You will need a different converter charger if you are going to lithium batteries, which is what I believe you are asking. The right one will depend on how many amp hours you need though, like the 100 amp-hour # 34282738. I have added a link below to our selection of lithium batteries as well as a solar calculator which will help you determine how many amp hours you need if you are unsure.
Then for a lithium converter charger we have the Progressive Dynamics 9300 Series RV Converter Charger... view full answer...
Although we do not have the instructions for the Replacement Controlled Motion Hinge for RV Entry Door # LC95VR that you mention I was able to get in contact with Lippert, and they were able to send over the instructions.
The instructions are as follows:
1.Find the center between the existing top hinge and the middle hinge and middle hinge and bottom hinge on the
outer frame and mark this spot.
2. Next, Spread open the hinge leafs 1, 3 and 5 that attach to the outer frame from leafs... view full answer...
It sounds like you have the Furrion Indoor RV Soundbar # FSB24SA2C-BL hooked directly to your T.V. The Furrion Indoor RV Soundbar # FSB24SA2C-BL is a passive soundbar, meaning it needs a separate power source, and can't be hooked up directly to your T.V.
Instead, you'll need to hook up the soundbar # FSB24SA2C-BL to an in-wall stereo like the Furrion RV Stereo # DV1230BL.
From here you'll use the HDMI cord to connect the stereo to the T.V., and then you'll take the output cables from... view full answer...
The Furrion RV Refrigerator # FCR14ACBQABL is rated for 1.268 kWh/24h which is the equivalent of 1,268 Watts so I recommend going with at least the Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch # PD64FR which is rated for 2,000 Watts.
The beauty of this inverter is that is has a built-in transfer switch so you'll actually be connecting both your battery bank and your shore power wiring to this unit and it will automatically pull power from shore power when you're connected... view full answer...
Yes we do, Steve. If your awning was made with the trailer in 2022 then you'd need the Replacement Motor for Solera Power RV Awnings Manufactured after 2015 # LC373566 otherwise you'd need the Replacement Motor for Solera Power RV Awnings Manufactured before 2015 # LC266149. view full answer...
The Excel RV Tankless On-Demand Water Heater # EX93FR is not meant to be mounted outside but can be mounted pretty much anywhere inside of your trailer with the exception of a bedroom or bathroom. It just requires 3" of clearance on the sides and 8" of clearance above.
It does not have freeze protection but it does have an ODS in place that will not allow unit to operate unless ventilated with adequate oxygen levels. view full answer...
I do have suggestions, and because there are no American-made ST235/80R16 load range G tires I suggestion going with the Westlake ST235/80R16 Radial Trailer Tire - Load Range G # WE76FR. It is not made in the USA, but it is made to USA specifications.
This is a 14-ply tire with a max load of 4,080 at 110 PSI. It has double steel belts and double polyester plies with nylon overlay. It has a speed rating of 75 mph.
I have added a link to a video review of this tire for you to check out... view full answer...
Go To Results