Yes, the SeeLeveL RV Holding Tank Monitor for fresh, gray, black - water pump and heater switch, # SE74VR is designed specifically to be a replacement for older tank monitoring systems. The SeeLeveL # SE74VR uses sensors that are sold separately for single-digit accuracy. The SeeLeveL sensors are mounted on the outside of the tanks, this means they are easy to install, won’t give false readings due to debris, and are easy to maintain. The SeeLeveL tank monitoring system uses technology... view full answer...
I reached out to Dexter and they no longer make that axle. I can confirm based on the bearing sizes you gave that you have a 3,500 lb capacity. If you determine you just want to replace the hub, I recommend the Trailer Hub and Drum Assembly for 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 # 84546UC3 or # AKHD-545-35-EZ-K if you have the grease zerk integrated in the spindle.
Since we can't match the spring seat to spring seat dimensions if you want to replace your axle I recommend using... view full answer...
If you are wanting to replace your Series 39 electric step directly then what you will need is the Lippert Kwikee 39 Series Electric Step # LC3724742 which comes with the motor, gears, control module, and switch kit with the wiring adapter.
Attached is a wiring diagram (which some of the connections are already completed) and an installation video for you to reference if you are going to be doing the installation yourself. view full answer...
We do have the correct replacement converter/charger for your system.
- Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers # PD4645V
The Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers # PD4645V works with Parallax/Magnetek model 6345 and has an integrated Charge Wizard. view full answer...
Yakima refers to the part you're needing as a clip spacer for their 1A RainGutter Towers, part # Y00101.
The replacement plastic clip spacers aren't available individually, they are included in the # Y8810136 replacement hardware bag, so potentially you could need both the # Y8810136 parts bag as well as the # Y8810008 replacement boots. This being said-as outlined in step 10 of the linked instructions you will not need the clip spacers if the backs of the roof rack feet do NOT touch the... view full answer...
The Firestone Air Ride system that fits your 2013 Ford Van and uses the 6781 air bag is the Firestone Ride-Rite Air Helper Springs # F2153. The correct replacement parts are listed below:
- Replacement Air Spring for Firestone Ride-Rite Kit # F6781 (this is the 6781 bag)
- Replacement Lower Bracket for Firestone Ride-Rite Rear Helper Springs # F5092
- Replacement Carriage Bolt for Firestone Air Springs # F2135821149 (x2)
- Replacement 3/8"-16 x 7" Carriage Bolt for Firestone Ride-Rite... view full answer...
The recommended 55A replacement for your Parallax 7300 would be the Progressive Dynamics # PD4655V for flooded lead acid, AGM and Gel batteries.
Progressive Dynamics offers a 1000 watt pure sine-wave inverter/transfer switch, part # PD1210SR that would be a good choice if a 2000 watt surge/1000 watt running output would meet your needs.
I've linked to product description videos for the items mentioned above. view full answer...
In order to retain your current suspension geometry, you'll need to use an equalizer of the same length and height as the 7-3/4 x 2-7/8 equalizer you currently have. The Dexter Axle # K71-449-00 offers equalizers that are the same width and height as what you have now. The only difference is that the shackle links are a tiny bit shorter, at 2-1/4 inches versus the 2-1/2 you currently have. This difference is very small and won't be enough to have a negative effect on your suspension geometry.
Thanks... view full answer...
Thank you for including a photo; it's always a huge help!
I may have a solution for you, but I'm not seeing anything we have as far as replacement lenses that would would for this Command Electronics tail light on your 1999 Gulfstream Class C. Additionally I'm not seeing anything close to your light as an available replacement from Command, so it might be discontinued and the light would need to be replaced completely.
If that ends up being the case we do have some options that are... view full answer...
If you are needing to replace the 4-way on your 2007 Ford E250 you can use the Curt T-Connector Vehicle Wiring Harness, # C56020.
If you are actually looking to convert the 4-way to a 7-way you will need to use adapter # 37185. Your current 4-way will just plug into the 4-way plug on the adapter and the remaining 4 wires will need to be connected as follows:
White - Ground to the vehicle frame.
Black - Connect to battery with fuse or breaker for 12V power.
Blue - Connect to Brake Controller... view full answer...
According to Lippert, the closest they can get to the 22 inch by 6-1/2 inch bolt pattern of your existing step would be the # LC372261 Kwikee 32 series, which has a 22 by 8 inch bolt pattern. Although you'd need to drill a couple of holes, the Series 32 would be your best bet as they don't have a 2 step option that would match up exactly to your existing bolt holes.. view full answer...
Depending on the 7-way connector you presently have, we might have a very easy solution for you.
Take a look at your existing 7-way, and see if it's possible to unplug the factory harness from the back of the connector. There will be a gray locking tab that needs to be slid toward the front of the vehicle before the connector can be unplugged. If it's possible to unplug the harness, the Tekonsha # 74682 would be a perfect plug and play replacement.
If you cannot unplug the connector from... view full answer...
The Firestone Ride-Rite Air Helper Springs # F2061 that fit your 2006 Ford E-350 motorhome chassis use the Model 268C Air Bag # F6764. If the air bag kit is fairly new you're probably okay just replacing one, but if you've had them for a while now I recommend replacing both so they have even wear. Then you can hang on to your current air bag that's in good shape in case of an emergency.
Pricing can be found on the product page. view full answer...
I do have a replacement 4-way option for your 2010 Ford Van, but it doesn't quite install like your factory harness did. You'll need the Curt # C56020 which plugs in inline of your tail light connectors and gives you the functional 4-way connector you're looking for.
I have attached an installation video of the # C56020 for you to take a look at. view full answer...
It looks like we do have the Right Angle 2-Wire Pigtail for Peterson Trailer Lights - 2-Prong PL-10 Plug - 6" Lead # B162-49 that will definitely fit your 164R lights. Unfortunately, Peterson does not offer a pigtail that has pass-through capabilities at this time.
However, what you may be able to is use something like the Quick Splices - Self-Stripping Connector - Closed Port - 14-16-18 Gauge - Blue - Qty 1 # SWC502905-1 to quickly and easily splice one black wire to the next. view full answer...
To replace just the hat bushing for your Roadmaster End Link Kit # RM-590230-00 you will need the part # RM-205223-00. For the metal sleeve that the bushings install around you will need the part # RM-205501-00.
Each of these will include one bushing or sleeve so in order to replace the bushing and sleeve on both ends of a single End Link you will need to order a quantity of 2. If you need to replace both ends on both of the End Links you will need 4. view full answer...
The screws that are part of the hardware cannot be purchased separately from the Replacement Mounting Hardware for Lippert Solera Slide Topper # LC701665.
Those screws are only with this kit. view full answer...
It sounds like you're looking for a replacement spring for a rear Firestone Ride-Rite system on your 2005 E-450 Class C motorhome.
The part # F9000 that you mentioned won't fit your application but we do have replacement air bags that should, depending on what air bag kit is installed on your motorhome:
Air Bag Kit # F2153 - Replacement Air Spring # F6781
Air Bag Kit # F2377 - Replacement Air Spring # F6397
If you have something else please let me know so I can assist you further. view full answer...
Go To Results