Video Transcript for A Closer Look at the Phoenix USA Rear Wheel Center Cap

Today, we're going to take a look at the Phoenix USA stainless rear wheel center cap for the eight on 275 millimeter bolt pattern with a six-and-a-half inch axle diameter. And this is for a quantity of one cap. Now, this will add a nice touch of class to your wheel. Creates a nice finished look by covering the rear hub with this polished stainless steel center cap. It is designed to fit over a rear axle with a six-and-a-half inch axle diameter. And the center cap covers the hub on the rear wheel, so when you go to install it, you place the wheel's center cap on the hub before installing the tire and wheel.

It adds a nice finishing touch to the wheel.Again, it's a polished stainless steel construction, which is very durable and rust-proof. It does come with the mounting bracket and the extra long three-and-a-half inch attachment bolt. How to install this, it's a center hole mount design. You can see the hole right in the center of the cap here. So, you'll start with the mounting bracket, and you'll remove two opposing axle nuts and lock washers from the axle end plate.

And basically, you'll take one nut and washer off here, and then directly across from it, another one. And you have your two exposed axle studs. Install this mounting bracket over those studs, and then reinstall the lock washes and nuts. Tighten it to factory torque specs. And then, this bracket will be installed on the end of your axle.What you'll want to do is take your rear hub cover, put it over the bracket and the hub, and then align that hub cover center hole with the threaded hole on the mounting bracket.

Once it lines up, just take your attachment bolt, stick it through there, and insert it into the threaded portion, and just tighten this down until it holds the hub cover onto your axle. Again, this is designed to fit the rear wheel. The wheel bolt pattern it fits on is a eight on 275 millimeter. Axle diameter again is six-and-a-half inches. And it is for a quantity of one center cap with a mounting bracket and the attachment bolt.The last thing I want to do is just give you some dimensions on this.

The diameter from edge to edge is probably right at nine-and-one-eighths inches. And the overall height of it from the bottom to the top, it's going to be also at nine-and-one-eighths inches tall.But that should do it for the review on the Phoenix USA stainless steel rear wheel center cap for eight on 275 millimeter bolt pattern with a six-and-a-half inch axle diameter.