TireMinder Straight Valve Extender - 2" - Qty 2

Video Transcript for Checking Out the TireMinder Straight Valve Extender

Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at the TireMinder two inch long Straight Valve Extenders for a quantity of two. Now these valve extenders will allow you to add an additional straight two inches of length to your metal valve stems to let you easily inflate or check the air pressure on those hard to reach valve stems. Now these are designed to fit metal valve stems, they're not recommended for use on rubber valve stems. They are a nickel plated brass construction and they are TPMS compatible. Total length on them, again, is two inches.

And basically, when these install one end right here is what'll screw onto your curve valve stem, and then the other end has the metal valve cap on it. And just to show you, I'm gonna pull out a metal valve stem to show you how they install. Pretty simple. But here's your metal valve stem with the cap on it. Just remove the cap that's on your valve stem, that's on your wheel.

Take your extension, put that end over that and then just start screwing it down. And you do wanna tighten it up. There is a seal inside there, so tighten it, snug it up and that'll make a nice good seal so there's no air leaking. And then when you go to access your air pressure, just go to the extension, take off your valve cap, and then put your pressure gauge on there or your air hose. And then when you're done, just go ahead and put the cap back on.

So they are very easy installation. But that should do it for the review on the TireMinder two inch long Straight Valve Extenders for a quantity of two.